2005 KitchenAid Dishwasher(Model#KUDI02FRSS1): The control panel console lock light was flashing continually after it washed awhile in the normal cycle, then when the cancel button was pushed, it would drain and then the lock light would start flashing again.
This is caused by a stuck key on the console control keypad assembly.
ERROR MESSAGES
STUCK KEY:
If the control detects that a key is stuck in the depressed position,
dishwasher operation will be suspended and the control will flash
the light for that key until the condition is corrected. If a key without
a light is stuck or multiple keys are stuck, the control will flash the
Lock-Out light.
I installed a new console control keypad assembly, worked great.
Black Console Part#8572494(Black)

White Console Part#8572495(White)

Stainless Console Part#8572496(Stainless)

Frigidaire Dishwasher(Model#FDB421RFR2): Not cleaning the dishes at all in any cycle. This has been a major issue for Frigidaire for many years now, but they have made a new Motor/Pump Assembly to solve this problem. Its works great!
Wash motor & pump kit
Part#154291501

Sears Kenmore Dishwasher made by Whirlpool (Model#665.17032401): The clean light was blinking 7 times and the dishwasher would not start in any cycle, the only button that would work was the cancel/drain button, but then after it drained it would go back to the clean light blinking 7 times. This indicates a problem in the heating circuit, and the element being bad is usually the main cause. I installed a new one, it worked great.
Part#8563007
Heater element assembly

Maytag Dishwasher (Model#MDB7600AWQ): The dishwasher was making a loud grinding sound, I found a walnut shell in the chopper/grinder filter screen area, I cleaned out the filter/flowplate assembly, worked great.
Part#99003291
Filter & flowplate assembly

Whirlpool Dishwasher(Model#DU910PFGB0): Making loud noise in the wash and drain cycles.
I found all kinds of glass and fruit seeds down in the pump impeller assembly, and the impeller was broken due to all that as well.
Installed new pump impeller kit, worked great.
Dishwasher drain & wash impeller kit with motor shaft seal

2003 KitchenAid Dishwasher(Model#KUDS01FKSS01): The control panel display lights were all dead, nothing would come on. I turned off the house breaker to the dishwasher then opened up the control panel by taking off all the inner door screws, that will also release the front outer door panel.
Then I used my volt/ohm meter to ohm out the thermal fuse that’s attached to the control board to check for continuity. There was no continuity, so I replaced the thermal fuse assembly with the wiring that was included with it, thats a must, and it worked great.
Part#8193762
Fuse kit with wire harness and instructions