Search by part number or model number for best results.
If you don't know your model number - try searching by appliance type, brand or part type.

Archive for The Daily Diary 2

Dec
09

Amana Glow Bar

Posted by: Jake | Comments (0)

1992 Amana Range(model#AGS745W–manufacturer#P1113904S): The oven would not heat up, the bake glow bar ignitor would start glowing slowly, but was worn out, with normal use, and it wouldn’t send a signal to the safty valve to let the gas come out to the bake burner.
The oven ignitor will need to be replaced.
Part#0309159
Common long ceramic oven and broiler igniter

2198

Have a good evening and weekend!
South Willamette Valley
…including cities of Eugene, Springfield, Corvallis
Issued: December 09, 2005 09:49:36 PST
Today: Mostly sunny. Patchy freezing fog in the morning. Highs 40 to 45 light wind..
Tonight: Clear in the evening…then partly cloudy. Areas of freezing fog. Lows 25 to 30 light wind.

Categories : The Daily Diary 2
Comments (0)
Dec
01

Whirlpool Range

Posted by: Jake | Comments (0)

2004 Whirlpool Range (Model#RF388LXKP0): The control board/clock was not working at all. Checked for 120 volts to the control board, that was ok. The control board shorted out. Installed new one, worked great.
Part#8522527
Cntrl-elec, (White in color)
(The manufacturer has replaced part number 8522527 with this item, part number 8523332.)

941209

Have a good evening!
South Willamette Valley
…including cities of Eugene, Springfield, Corvallis
Issued: December 01, 2005 14:45:29 PST
Tonight: Showers. Lows around 35. South wind 10 to 15 mph.
Friday: Showers. Highs 40 to 45. Southwest wind 10 to 20 mph.

Categories : The Daily Diary 2
Comments (0)
Nov
19

Magic Chef

Posted by: Jake | Comments (0)

Magic Chef Range(model#CGR1420BDQ): The oven igniter glow bar comes on but does not signal the safty valve to start the gas flow to the burner. The problem is the oven igniter is bad.
These are easy to install, just take off the bottom cover of the oven, then remove the flame shield, and you will see it.
Manufacturer specified oven and broiler igniter kit
ovenigniter.jpg

Have a good weekend!
South Willamette Valley
…including cities of Eugene, Springfield, Corvallis
Sunday: Mostly cloudy. Areas of fog. Highs 40 to 50. North wind 5 to 10 mph.
Sunday Night: Mostly cloudy. Areas of fog through the night. Lows around 35. North wind 5 to 10 mph.

Categories : The Daily Diary 2
Comments (0)
Nov
16

Outer Tub Assembly

Posted by: Jake | Comments (0)

Sears Kenmore made by Frigidaire(model#41743042200): Very loud banging sound when its spinning, and leaking water from the middle of the drum from where the 2 sides bolt together.
The problem is the Rear outer tub bearing and shaft seal is worn out. Also on some of these the spin basket spiders can break.
This is a major repair, its a complete teardown of the washer installing the new parts, it can be a 2-4 hour job.
Part#131462800
Rear outer tub assembly with bearing and shaft seal

407639

Part#131618500
Inner tub with spider and shaft

407854

Have a good evening!
South Willamette Valley
…including cities of Eugene, Springfield, Corvallis
Issued: November 16, 2005 21:02:46 PST
Tonight: Becoming mostly cloudy with areas of fog. Lows around 35 light wind..
Thursday: Mostly cloudy. Areas of fog. Highs 45 to 50. North wind 5 to 10 mph.

Categories : The Daily Diary 2
Comments (0)
Nov
11

Kenmore Timer

Posted by: Jake | Comments (0)

Sears Kenmore Washer made by Whirlpool(model#11022722101): The timer was stalling in the wash cycle, found burned out contacts in that part of the timer cycle.
The timers are fairly easy to replace, Jeff from our forums has a great how to section on his website
Part#3955193
Timer
(The manufacturer has replaced part number 3955193 with this item, part number 661649.)

909246

Have a good weekend!

Categories : The Daily Diary 2
Comments (0)
Nov
07

Range Bake Element

Posted by: Jake | Comments (0)

Sears Kenmore Electric Range made by Whirlpool (model#665.95002101): Oven is not heating when the bake cycle is on, I always make sure the range is receiving 240 volts at the range terminal block, a volt/ohm meter is a necessity. If that checks ok, then I check the the bake element for continuity with the ohm meter, make sure the power to the range is off first before testing the bake element for continuity.
There was no continuity in the bake element, when i checked it.
Part#8053713
Oven bake element assembly with push-on terminals

1028468

Have a good evening!
South Willamette Valley
…including cities of Eugene, Springfield, Corvallis
Issued: November 07, 2005 14:43:40 PST
Tonight: Mostly cloudy in the evening…then partly cloudy. A chance of showers. A slight chance of a thunderstorm this evening. Colder. Lows 30 to 35 light wind..
Tuesday: Partly cloudy with a slight chance of rain. Highs around 50. South wind 5 to 10 mph.

Categories : The Daily Diary 2
Comments (0)
Nov
04

Refrigerator Door Gasket

Posted by: Jake | Comments (0)

2004 Sears Kenmore Top Mount(Freezer on Top) Refrigerator made by Frigidaire(model#25363712302): The Refrigerator door gasket is not sealing properly, found a torn spot in it. These gaskets seem to hold up pretty good, but every once in awhile you may see a loose, torn, or crimped door gasket.
They used to have screws that held them in place, but now most are the push-in type, which is a great time saver!
Part#240542106
Gasket-refr door

941574

Have a good weekend!
South Willamette Valley
…including cities of Eugene, Springfield, Corvallis
Issued: November 04, 2005 04:20:26 PST
Today: Showers. Highs around 50. South wind 15 to 20 mph.
Tonight: Showers likely. Lows 40 to 45. Southwest wind 5 to 15 mph.

Categories : The Daily Diary 2
Comments (0)