Activity Stream

OK sounds good Keep us posted. Hose Adapter 40008101 Order now for same day shipping. 365 day return policy. RepairClinic.com

Thanks for the reply over the weekend I am going to plug it back up now and do these checks when it stops cooling. When you say check the supply...

Thanks Rick. I'll give it a try over the next few days.

Takes Jake for your reply, I will get a meter tonight and check it. Will update you with the results.

You have a defrost problem. There are only three components that make up the defrost system in a refrigerator, the defrost heater, the defrost...

Chris, try this: Remove the lower panel and locate the Hi-limit thermostat. It's inline with the heater. Remove the two wires from the thermostat and...

Thanks. I ordered the pump. Since I needed to empty the water again I came up with a dryer method involving a 1"pan and shop vac. That worked so well...

Hi Jake, I have a Maytay stacked washer/dryer Model number MLE2000AYW, Serial Number 59864004AT. It just tumble but doesn't spin during the spin...

Yea! It is working beautifully! Thank you so much for your help!

Static and working? What where the readings? I pulled a diagram online and can't see anything else that would effect both at the same time...

Excellent John, good job, glad to hear that.:) Jake

Maintop Assembly Removal 1. Turn power off to unit or unplug it. 2. Open oven door and remove screws securing maintop to oven chassis, located on...

That explains it then, its not the same as your original OEM. I even saw a review from one person say "not the same". Read my post#2 here: Don't...

Because when you clean the oven the door has to lock, then when cleaning is done after it cools down the door latch lock should release to open the...

Yes, then you'll need a new motherboard, but first let me ask: When you notice the temperature rise is the refrigerator still running or dead silent?...

No Joe, your not checking continuity, your checking for 110 volts between 4M and 5M on the motor switch, I know its a bit difficult to do because you...

I got the part very quickly and installed it without a hitch. We gave it a go on the Permanent Press setting, the most troubled setting, and it...

Its likely the gas valve. You will need a multimeter to test ohms. Turn the breaker off to your range, Set your multimeter to check Ohms on the...

The thermal fuse and thermal cut off have been bypassed. This is a very bad thing. The machine has obviously been over heating and each time the...

Jake, Thanks. Is there any information you can give me on how to access and replace the burner? Looked for screws on the underside of the...

I know this problem can occur with the design of the machine so I looked up your model and I found the siphon break and coupler listed in the parts...

Is the drain hose connection on the back of the machine at the top of the machine or the bottom?

Rick, thanks for the reply. What you describe makes some sense. However, what you describe doesn't fit what we've observed in this situation. ...

Another update: To eliminate a bad wire as a cause, I've checked where wires attach inside the unit and sure enough, proper voltage there too....

Bret, check the three secondaries for the correct voltage. The voltages are listed in the diagram. If the voltage is correct, the EOC is faulty:...

Hi Jeff- thanks for the reply. It's a GLET1031FS4. I opened the small access panel where the wire enters the unit and the wires are all still...

I purchased it about three weeks ago from a vendor on Amazon. The unit was new in it's FSP box. Although, it was manufactured in September 2011,...

Hi, I found GLET1031FS0 GLET1031FS1 GLET1031FS2 GLET1031FS4 Check it where the cord/power wire enters the unit....sometimes a wire will...

I believe the problem to be a combination of a couple things. Newer plumbing codes state the drain tube for a washing machine be 3". Your machine has...