Kitchenaid Surpeba Normal Light Blinking all

[mikeperez]

My Kitchenaid died when doing a rinse, the Normal and Rinse lights just keep blinking - I have changed the control board, user interface, and the fuser kit .

No changes just keeps blinking - tried to put in diagnostic mode but no luck.

Anyone can help -KUDS01fksso

Mike

[Jake]

Hi,

Does your control panel have a ribbon cable that connects to the user interface?

Is the any electronics on the black control panel at all?

Jake

[mikeperez]

It has a ribbon cable connected , no breaks

User interface remains the same all the time , just blinking light on Normal and rinse remains lite.

Changed and reset breaker no change, used a different circuit no change

Mike

[Jake]

I seem to remember a tech. a Sears tech. ordering the same parts you did, and I installed them and that dishwasher
would do the same as yours, then i noticed the part# was different on the user interface.

This part# list here is the correct one for this model, just check if yours matches this one.

User interface part#8270168 (http://www.repairclinic.com/referral.asp?R=1265&N=909664)

If it does the only other thing it could be is the control panel itself:

Panel-cntl
(The manufacturer has replaced part number 8270161 with this item, part number 8524443.) (http://www.repairclinic.com/referral.asp?R=1265&N=905610)

Jake