Premium Member
Kenmore Ultra Elite Power, but won't run
Model Number: 66516989200Brand: -major brand-
Unit stopped in cycle. About a year ago the thermal fuse went out on this unit and was replaced. I don't think that's the problem now, because there is power at the control panel. You can push any of the buttons and get it to light up, but it won't start.
The start button looked indented and very warn.
Any ideas?
Jason
Premium Member
New information. My wife just tells me she smelled something electrical before it quit. I opened up the control panel, heres what I found:
- melted connector
- burned control assembly (one of the post the to connector is off)
So, it looks like I'm going to need to replace the electronic control assembly. What about the wiring connector? Can one order one of these as well?
Last edited by jason76; March 8th, 2010 at 05:07 PM.
Appliance Tech
A wiring harness would be required. You could always clip the wires and just spice on 1/4" terminals for that repair. You may want to check with sears. Some of these models were recalled due to heater issues. The heaters were drawing too much current and taking out the boards. Not sure if yours is one of the ones affected or not.
Justin Shaffer
In Home Appliance Service Technician
Appliance Tech - Admin
Here's the control board for your model you can order:
Manufacturer's Number: 8564542
Here's the wiring harness for your model:
Manufacturer's Number: 8534932
Jake
Appliance Repair School 1987-1988
Star Appliance Tech. 2 yrs. 1988-1990
Wards Appliance Tech. 11 yrs. 1990-2001
Sears Appliance Tech. 4 yrs. 2001-Oct. 2005
Jake's Appliance Repair Nov. 2005-present
Look-Up & Order Parts
ApplianceBlog Classifieds
Posting Permissions
Reply With Quote