December 27th, 2012, 07:56 AM
Maytag Dishwasher - Unable to change settings
My dishwasher is not able to change settings. There are no settings lit up in the "cycle" section or sometimes the heavy wash will be lit. In the "options" section heated dry, sanitize and high temp wash are all lit up. I cannot make any changes. I can turn the dishwasher on & it runs, however I am not sure on what cycle. For the most part the dishers are coming out clean. I turned the power off to the unit for 30 minutes then restored it. It did not make a difference. Any suggestions would be greatly appreciated.
December 27th, 2012, 10:04 AM
Missing the last digits.
Certainly sounds like new key panal time ( MDB8951BWW10, MDB8951BWW01, MDB8951BWW44, MDB8951BWW41 ) all of these -appear- to have been replaced with the same part...
Touchpad and control panel Manufacturer Number W10161784
December 27th, 2012, 06:55 PM
How hard is it to change out this panel?
December 27th, 2012, 08:06 PM
December 30th, 2012, 12:33 PM
Point taken! Is there any manual or anything to guide in fixing it?
Thanks for the help!
By El Mürko in forum Dishwashers
Last Post: December 9th, 2012, 07:00 PM
By stlucia in forum GE/Hotpoint
Last Post: October 26th, 2011, 12:30 PM
By shenoka in forum Maytag/Magic Chef/Admiral/Jenn-Air
Last Post: July 5th, 2011, 09:06 AM
By wkmida in forum KitchenAid
Last Post: May 20th, 2011, 10:22 AM
By bobj in forum Sears Kenmore
Last Post: July 21st, 2005, 10:52 PM
If you feel that you have benefited from this site, and would like to show your appreciation, you can throw a buck or two in the Appliance Blog Tip Jar - Thank you!