January 23rd, 2013, 02:26 PM
Samsung washer dc error during spin
During spin cycle washer will not spin at full speed. It spins at slow speed, starts to speed up and then stops and repeats the process. Eventually it give "dc" error.
During a "test spin", it will go ahead and spin up to full speed, but it shakes a little bit as it builds up speed. The shaking diminishes as it gets to higher speed.
January 23rd, 2013, 04:47 PM
The shaking is why you're getting the dc error code. An unbalance or cabinet bump was detected during the final spin and won't let it exceed 400 rpm. Check for the cause of the unbalance condition.
OWNER RICK'S APPLIANCE REPAIR
APPLIANCE TECHNICIAN FOR 29 YEARS
ONLINE SERV TECH: ApplianceBlog.com
CERTIFIED TYPE 1; TYPE 2.....REFRIGERATION SERVICE E.S.
By KRavEN in forum Dryers
Last Post: September 2nd, 2012, 03:00 PM
By ericdiy in forum Washers
Last Post: May 12th, 2012, 12:56 PM
By bsaucer in forum Dryers
Last Post: March 18th, 2012, 06:14 AM
Last Post: April 22nd, 2010, 09:18 PM
Last Post: April 21st, 2010, 10:57 PM
If you feel that you have benefited from this site, and would like to show your appreciation, you can throw a buck or two in the Appliance Blog Tip Jar - Thank you!