I went out on a service call and the complaint was water constanting dripping into the tub at all times, even when the washer was not being used. Over time the water inlet valve wears out and causes this to happen.
I replaced the water inlet valve and it worked great! No more dripping water into the tub.
Here’s the water inlet valve for this model:
WP22002360 Water Inlet Valve
There is a video in the water inlet valve part link that shows you how to replace it.
The washer would drain, but not spin. I replaced the shift actuator and it worked good.
This is the shift actuator for this model:
There is a “HOW TO” video when you click the part link to the shift actuator.
I explain in detail “HOW TO” test this shift actuator in our appliance repair forums: FIXED: WTW4800BQ0 Whirlpool Washer Won’t Spin
There is a data sheet in each washer, you have to raise the top on the washer, then it will be located inside the front panel on the left as your standing in front of the washer.
This video shows you “HOW TO” raise the top of the washer: Whirlpool/Kenmore Top-Load Washer Disassembly
The washer was just making a clicking noise as the lid switch was trying to lock but it was broken and couldn’t lock.
Replaced the lid lock switch assembly. Worked great!
Here’s the lid switch for this model:
W10404050 Lid Latch Assembly
“How To” video included in part link.
I went out on a service call and got the error code F5 E3 which is DOOR UNLOCK ERROR. The door latch lock with lock then unlock about 3 times then display F5 E3.
I replaced the door latch lock switch assembly and its fixed.
Here’s the door latch lock switch assembly for this model:
Bouse, AZ Forecast:
Partly cloudy, with a low around 52. East wind around 5 mph.
Mostly sunny, with a high near 85. East southeast wind 5 to 10 mph becoming southwest in the afternoon.
Model number LSR7300PQ2
The drain hose that goes from the water pump to the customers drain pipe was leaking near the bottom left side suspension support bracket of the washer.
Drain Hose W10096921