clutch

  1. G

    FIXED Maytag Centennial MVWC300VW1 Clutch Bad?

    Hi Folks, I'm new to the forum. My Maytag Centennial sounds like the agitator is slipping and not rotating as much as it should during the wash cycle. It's also quite loud as you can see in the video. The clothes are not really spinning too much either. I've read that the clutch may be...
  2. F

    FIXED Removing clutch from old GE washer motor

    Hello forum, I am attempting to reuse an induction motor from an older GE washer. I have successfully removed the top cap/cover, clutch housing (w/ included sheave and bearing), and a few other small components. Here is the assembly before any components were removed, as well as before...
  3. L

    FAV6800AWW Maytag Washer Squealing

    Help! my washer stopped working during the spin cycle and continuously gave me the codes that it was unbalanced. after researching, took the drive pulley off and cleaned the clutch well. I did notice the pin in the clutch was loose. I got it all put back together and now when the washer is...
  4. M

    LSQ9110LW0 Whirlpool ultimate care ii spin/agitator issues

    So I've got a couple issues I'm dealing with on an old washing machine. Model number LSQ9110LW0. Machine was leaking and leaving water in the bottom of the drum after cycles. I replaced out the water pump that stop the leaking problem but the machine still wasn't spinning properly. I replace the...
  5. G

    LG WT5001CW Spline on new clutch is the wrong size

    I ordered a new wash plate a few years ago and it fit fine. I had to replace the clutch assy. recently. Ordered the part and installed. It started the UE code so I figured the splines was stripped again (common problem) When I removed the wash plate, I discovered the spline on the new clutch was...
  6. K

    FIXED Two Months After Clutch Replacement, Getting Soggy Spin Dry

    My Kenmore 110.92588210 washer was purchased new in 1996. I replaced the basket drive and brake assembly and the clutch in December 2012. I replaced the motor coupling in July 2013. Two months ago I replaced the clutch because the spin dry was getting slower and slower, then finally quit...
  7. S

    20 y/o Kenmore with bad clutch symptoms, but it's not the clutch. Please help.

    20 year old Kenmore 110.92593210 has the classic symptoms of a bad clutch: Slow to spin Easy to stop by hand (sometimes) Worse under heavy load Sometimes needs help to start spinning with heavy load Clothes come out soaked after slow spin Bought a new clutch kit. Easy job. Looked at old...
  8. O

    FIXED Estate Washer won't spin

    I just replaced the clutch in this washer since it would not spin and that's what the internet said it should be. When it still wouldn't spin I tilted it back and watched as the spin cycle started. The first thing I noticed was the brake disengaged when the spin cycle started and the clutch...
  9. M

    Kenmore 90 Series Washer Still Not Spinning After Clutch Change

    Recently the washer started making some loud humming/whining type noises and it would not spin. The machine agitates, although does not spin on the spin cycle. Things I have done so far: Checked the coupling (all good, replaced about a year ago) Replaced clutch with new clutch let the machine...
  10. P

    Washer not spinning cloths dry and making noise when changing cycles

    I can re-spin the cloths somewhat less soggy so they can go into my cloths dryer. But that doesn't help with jeans or towels. I've also noticed a loud clunk noise when it changes from the wash cycle to rinse/ spin cycle. I've searched and it seems like it's my clutch possibly. Would you agree or...
  11. F

    800 Series washer does not always spin

    Hi; My Kenmore 800 series washer has been leaving the wash very wet recently. Today, I found that it was not spinning at all, although it had drained the water. I tried every cycle but could not get it to spin. Then (with the machine stopped) I gave the tub a slight push clockwise. There was a...
  12. T

    Agitator stiffness prevents spin after clutch/brake replacement

    I replaced the brake/clutch assembly after my WP would not spin or agitate. After the repair it worked great for a few days. Now, it agitates during wash cycle just fine, but during the spin cycle the agitator seems stuck or stiff, and if the clothes are resting on it, the tub will not spin...
  13. K

    FIXED Kenmore Washer Agitates But Does Not Spin

    Our Sears Kenmore 110.92588210 washer was purchased new in 1996. A few days ago we noticed the agitator still works but the basket no longer spins - the washed items never spin dry. I saw from other posts on this forum where people described a similar problem, and that a clutch and basket drive...
  14. F

    Estate Washer not draining completely

    I have a Whirlpool Estate washer that's 4 years old I recently purchased from an elderly lady. It has worked fine for a month or so but started to not drain all the way. Clothes are still soaked and a little water is left in tub. We noticed when we tried to remove more of the water by putting it...
Top