control board

I THINK I need to order a main control board. Hoping to get some confirmation or recommended additional testing to do before ordering. Built Feb 2014 (6 yrs old). Freezer section stopped sufficiently cooling a couple weeks ago (was around 45-50 degrees?). Ran diagnostics at that time, all fan...

Model: MAH6700AWW Issue: Spin cycle during wash will not spin high speed. However, a manual spin only cycle will spin high speed. (Symptoms may vary. This was my experience) Problem: Capacitors on the control board have weakened and are starting to fail Resolution: Replace control board...

LG 2012 model: LSC5683WS/02 control board number: control board: 6871W1N009H Hello, my problem is some button are not working like the start. Since i tried already to clean the ribbon cable/disconnect,reconnect everything, i know the problem will be the control board or the keypad board...

I decided to make a new thread for this instead of go off topic on that thread. This Saturday, I came to my machine with my towels still pretty soaking wet. I put the dial in spin/drain and pressed the button, but it never went into spin mode, drain pump was going strong. I uplugged the...

Hoping to get some help- so glad to find this place. I have a Kenmore electric double wall oven, model 790.49533312- I think it might be about 8 years old. Unfortunately, the top oven will heat up to temp, but won’t stay warm. When I select ‘bake’ it gets up to temp, and then immediately allows...

Hello , i have a whirlpool duet model GEW9200LW0 that stopped heating. I've checked the thermostats, thermal fuse, thermistor (10.7 at room temp), and the heating element and they all check out. Controll board maybe....i haven't gotten any codes on the screen except for pf once after i flipped...

Hello all, I'm hoping someone here can help me. I just replaced the control board on my range, and it seemed to work just fine. HOWEVER, when my wife went to use the range top, the board shut off completely (although the range continued to work). I shut off the breaker for a while and turned it...

My Jenn Air Dishwasher - It starts like normal for a minute...then the water swooshing stops, the blue light/control panel blink once...and it starts the process over again. It will do this endlessly until stopped and I have to manually hit "Cancel" for it to drain (which it oddly doesn't stop...

Hey all, I have a 2 year old dishwasher that isn't starting. Thanks to this forum, I've tried all kinds of stuff. This happened about 2 weeks ago, and shutting off the breaker for 5 minutes fixed it. This time, I've tried everything. Reset the breaker, ensured demo mode wasn't on, and ran...

Hey Folks, RE: GY397LXUB02 Whirlpool slide-in range Issue: buttons that don't work - bake, numbers, clean, warm, favorites, timer, light buttons that do work - broil, clock, cook/hold, cancel I tried a replacement control board WP8507P392-60 and symptoms stayed...

My MDB7750AWB shows a completely unresponsive touchpad, except the "Start" button. :) Occasionally, the DW won't complete a run cycle, leaving two inches of clean water in the bottom of the tub but sparkling clean dishes. I can't run another cycle because the "Start" button is now unresponsive...

Hi, I have purchased this dishwasher five years ago. By now I have replaced the control board four times. The trouble I see is, it does not start. First time I have replaced the pump assembly, heater, and even the top panel, then I found out the main control board is not working. After that I...

this started yesterday after I tried to adjust the temperature for both the freezer and fridge. the display went out then i start to hear a clicking noise from the display. should i replace the dispenser control board? or the main control board in the back??? GE WR55X10859 Dispenser Control...

Hello, My GE GDT695SSJ0SS flashes for 10 seconds with an 815 error code. It really appears like the door is making a solid connection however. I checked the control board and I'm not seeing any green LED's flashing at all. Does this mean I should replace my control board? Or is it possible my...

So about a year ago I started having an intermittent issue where my LG Washer WM3360HVCA wouldn't power on. Either unplugging it or doing the hard reset, sometimes leaving it unplugged a couple hours or over night if necessary, but it would start working. Long story short, home warranty company...

I have a Maytag 5000 Series Dryer, Model: MEDE500VW1 I went to start the dryer and although everything lit up as usual, when I pressed start, all I heard was a "click" sound. After reviewing a few YouTube videos, I figured out how to place my dryer into test mode by pressing + — + —. The...

Yesterday we had a power outage from the hurricane. Everything seemed okay agter power was restored but I noticed later in the night that the fridge was not cool. Also the control panel on the front is not working. I tried unplugging it for 10 minutes and and plugging it back it but it just made...

My Whirlpool Duet Steam (WFW86HEBC1) has no power to the control panel. No lights work. No buttons work. The machine is slightly over 5 years old. It appears to have failed near the end of the load it was washing. Initially, I couldn't get the door open, but I took off the top of the...

Hello, I want to thank you in advance to anyone who can shed some light on this! I bought a used fridge about a month and a half ago. After having it plugged in and running for around 3 weeks it randomly stopped cooling the fridge and freezer. All lights were operating but compressor was not...

My oven stopped heating. Both elements at the same time. Checked them both with a multimeter, and both checked out alright. Also checked the temperature sensor, and that checked out ok. I moved onto replacing the control board, and it powers up no problem, but I am unable to set the clock to...