control board

  1. L

    MED4200BW0 Maytag Maxima X Control Panel has hot spot above power button

    Any one ever run into this problem? Maytag Maxima X steam dryer has a hot (to the touch) spot above the power button. It is hot enough it has turned the spot brown. I removed the control panel and found that a rectangular chip? is brown as well as a resistor looks brown as well. I am...
  2. L

    AC2224GEKB JAZZ 15 or JAZZ 14? door switch controlling compressor?

    I have an unusual problem: a few weeks ago my fridge stopped working . no previous rattling or noise, no burned odor , no symptoms. I unplugged and plugged the unit a few times but nothing positive happened. I call a technician (not specialized in this brand ) and he diagnosed a failed...
  3. R

    106.51172310 Kenmore Elite Not defrosting

    Hi. My refrigerator has been running fine. A little over a week ago, the fridge side turned warm while freezer side was cold. Checked and the coil on freezer side was packed with frost. Bi metal tested open (no continuity) with fridge off and defrosted. Also after running the coil a few...
  4. M

    GLTF2940ES3 Dial/controls out of whack since replaced control board

    Bought washer in 2007. Got error code suggesting problem with main control board, so replaced it. Didn't fix problem, got new error code suggesting problem with speed control board. Replaced that. Now washer works (at least, all the cycles we've tried do something plausible), but the...
  5. B

    FIXED 796.31523211 Kenmore Top Loader Fill Slows down after 30 seconds (IE Error)

    I have a Kenmore Elite top loader. I have been getting the IE (Inlet Error) The hoses are clear as are the inlet filters and the water pressure leaving the hoses is fine. When I start a load, the water fills fine for about 20-30 seconds but then "kicks" and the water fills VERY slowly...
  6. Z

    SHY66C05UC/14 Control Board wiring instructions

    I was having problems with my Bosch dishwasher where the cycle would never end. After troubleshooting I decided to replace the control board. I purchased a refurbished board and the dishwasher is cycling properly but the dishes are coming out wet and some of the dishes are not coming out...
  7. P

    FIXED SHU43C02UC/22....is it the pump or the control board?

    Hi I guess the best thing is to list the symptoms...LOL 1. Turn on, timer displays and washer fills (albeit more slowly than before) 2. Much clicking is heard 3. Timer does not seem to keep correct time (example it took more than 14 minutes for 14 minutes to run off timer) 4. Drain is...
  8. E

    FAFW3511KW0 Affinity front loader - lights flashing AFTER replacing control board and door mechanism

    A few weeks back my Affinity front load washer would stop mid-cycle. Sometimes I could re-start it and it would complete, but then it stopped completely. The initial error code went back and forth between E6E and E41. Here are the steps I took- 1. Checked drain and pump -> nothing clogging it...
  9. E

    FIXED DV42H5200EP Samsung Dryer - Heating Relay not Switching On

    Hi, I have a 2 1/2 year old Samsung Front-Loading Dryer (Model # DV42H5200EP) that has stopped heating. I tested the heating relay by probing both the blue and black wires (see attached schematic) on the heating relay individually between ground and measured 120VAC. I then measured the voltage...
  10. T

    GGW9250PL3 Whirlpool Duet Will Not Turn On

    I'm having essentially the same problem as some others have here but I'm not sure about the advice given out which is inconsistent. If you search the web there are many having the same problem where the dryer has power, the thermal fuse is fine, but the control panel will not turn on. The...
  11. D

    Jade RJRS4270A Electrical Issue

    I have a Jade 42" refrigerator model RJRS4270A. Jade was purchased by Jenn-Air then Whirlpool. I had a power surge a couple nights ago and in the morning the refrigerator did not operate. There are no lights, compressor doesn't run, no display panel etc. - completely dead. I have power at the...
  12. B

    FIXED Samsung DV36J4000EW/A3 - HE error, heating element and thermal fuses check out

    Hi all - HELP! After reading through the forums I figured my problem should be easy enough to solve. I've got a barely used Samsung DV36J4000EW/a3 that I bought two years ago for my seasonal home that had started to act up. At first, the dryer would run for 20-30 minutes, before stopping with...
  13. C

    FIXED Maytag Neptune MAH5500BWW control panel 3 beeps, won't enter service mode

    Washer (Maytag Neptune MAH5500BWW) control buttons are mostly letting out 3 beeps for any activity. Even pressing OFF button gives 3 beeps. Certain buttons will switch work, as in switching temperature, but overall everything just beeps x3. I've unplugged several times. Have unplugged for 10...
  14. M

    KSRP25FNSS00 Freezer side of Kitchenaid side by side refrigerator intermittently warms up

    I have an issue with my KSRP25FNSS00 side by refrigerator. Twice in the last 6 months the freezer side has defrosted. At the same time, all the lights on the controller are out. All the lights in the refrigerator and freezer work. It reminds me of the old days with a mechanical defrost...
  15. B

    Whirlpool YWFE38ILVQ0 charred/burned out wires on board

    Hello! My broiler element recently stopped working. Thinking it was the element itself, I took it out and checked for cracks and continuity. No cracks, and the multimeter showed continuity. After taking off the back, I see obvious evidence of a burning or flare-up on one of the connectors of...
  16. 9

    FIXED Thermador bad Board Error code 22 leads to Cooling Fan Error Code 43 & discontinued fan 00486894 FYI

    Thermador bad Board Error code 22 leads to Cooling Fan Error Code 43 & discontinued fan 00486894 FYI Hi DIYers! Posting this for posterity. We had a power outage and when we awoke our Thermador range PGR486GDZS/01 was blinking error code 22, which means bad control board. We ordered a new...
  17. D

    665.13152K701 Sears Kenmore will not heat the water.

    Our Sears Kenmore Elite will go through all of the cycles normally with no error codes, but it does not heat the water, when it gets to the dry cycle the element heats up and dries the dishes fine. We changed the High Limit Thermostat and it did not solve the problem. Is it correct to assume...
  18. B

    KDHE704DSS0 gone crazy

    My friends new dishwasher has gone from strange to bizarre. First the indicator light was off when it should have been glowing blue to indicate that the cycle was finished. Then he opened the door to discover that the dishes seemed to have been cleaned but the drying cycle hadn't kicked in. They...
  19. S

    KUDA03CTBS1 High voltage burnout of control board

    Hi all: So I have an oddly burned out control board for my dishwasher. It failed during a wash cycle or right at the end, possibly at pump out, with a complete shutdown (no life in the panel) and a burning smell. My hope was that it was just the bimetal fuse - which is in fact blown - but the...
  20. S

    WRS321CDBM00 Whirlpool Diffuser/Damper Opens and closes repeatedly

    I have a Whirlpool Side by Side WRS321CDBM00 refrigerator that is only 24 months old that is now warm in the fridge side, cold in the freezer and making popping noises every 10 seconds. I have tracked what was began as intermittent popping noise that started 3 days ago to now occurring...
Top