• Important Announcement

    It's with sad news to announce that our site owner, Jake, has passed away. You can read the details here.


  1. S

    Garland Sunfire X Series Oven Fire doesn't go low

    I am communicating here on the hope I can get some help since I have ran out of options locally. I am located in Lebanon-Middle East. I cook on a Garland Sunfire x series Gas range ( 6 burners ) 3 to 4 times a week only. It is 4 years old. Lately, the oven fire is no longer going low but...
  2. M

    FIXED ABC2037DES Amana Refrigerator ice maker not working

    the ohm reading across the motor was between 7 and 8Kohms so i think the motor is good. after re-supplying power i found no voltage at L and N. waited about an hour and came back later to find that the motor at some point rotated 90 degrees, tested between L and N and again no voltage. so i'm...
  3. A

    FIXED GTW485BMM0WS GE washer Personality

    Hello! Ge Washer, model GTW485BMM0WS New control board was installed on unit; control did not come with personality profile paper; apon looking up the mini manual, the washer says it needs to be programed to personality 10. Using step 17 on mini manual I went through the steps of changing...
  4. B

    FIXED GE Washer GTW460ASJ8WW - will not turn on after control board replacement

    -GE topload washer has always worked well. I think about 5 years old, could be more like 6 or 7 years old. -I stupidly tried to wash pillows. Pillows heavily laden with water, I tried numerous Drain/Spin cycles to no avail, always unbalanced, would start drain and spin but could tell load was...
  5. K

    LG Range LRE3083BD - Rear Burner Control Turns On Front AND Rear Burners

    LG Range LRE3083BD - When the left rear burner control is turned on, both the left rear burner AND the left front double burner turns on. At that point the controls for the left front double burner have no effect and the left rear control regulates both. If the left front burner is turned on...
  6. M

    PFCS1NFYASS GE Refrigerator - Odd behavior around temperature control

    Folks: 10 year old GE (PFCS1NFYASS). One day I opened it and the internal fridge lights were not on and I noticed it was warmer than it should be--yet we had power. I cycled the power and lights came on. It had been 2 years since I cleaned out the coils, so I did a through cleaning. Powered...
  7. V

    WFW72HEDW0 Whirpool Duet pump issue?

    Hi All! So, a few days ago, I started getting the E1 F9 Error, draining too slowly on my Whirlpool Duet WFW72HEDW0. I removed the drain plug and cleaned it thoroughly, I also removed the drain hose running up the side of the machine and cleaned it along with the exterior drain hose. I...
  8. M

    FIXED FGHB2844LF5 Frigidaire -- No Water to Ice Maker

    Hello! I posted here a few months ago about an ice maker problem and a fix external to the Fridge worked for a while. Unfortunately, I've been having similar problems again and wanted to check with someone here before ordering new parts. Here is the service manual for my fridge that Jake was...
  9. V

    GE GLD4404RBB not turning on, control panel wont accept any key press, led is on

    Hi, I was wondering if there is a support procedure for this GE dish washer when the control panel is showing random lights when I trip my circuit breaker, it is not accepting any key press, but LED lights are appearing on the front panel. The dishwasher motor or pump will not turn on. It will...
  10. T

    Whirlpool 2000 series weird blinking lights

    Hi I'm new here and I'm having a lot of trouble with this. We fixed the computer/control board on it and it powered up but now it's just blinking like crazy and locking and unlocking itself. Also displays an error message 8 on it. I have a picture of it but I'm not sure how to post it. Any help...
  11. H

    FIXED ED25RF Refrigerator Cooling Control Problem - Too cold

    My old girl has developed a cooling problem. The normal thermostat setting (on the refrigerator) got everything too cold. The freezer section had ice forming, the Ice Maker had icicles dripping down, the fill tube fully frozen. Portions of the ice bucket had defrosted and re-frozen. The...
  12. G

    FIXED Whirlpool Duet Dryer Control Panel Replaced (Twice), Worked, Now Non-functioning Again

    Hello, I recently had to repair my dryer as it was non-responsive from the control panel but had the tub light on and following the advice of this forum (FIXED Whirlpool Duet GEW9250PW0 Dryer is down) I was able to replace the Control Panel Touchpad User Interface and the dryer worked! For a...
  13. T

    FIXED KUDK02CRBS0 Intermittent panel lights, then no lights and no response

    I don't know much about the history of this appliance since it was already in the home when we moved in about 6 months ago. I'm guessing it's at least 5+yrs old. About one month ago the control panel buttons started acting up a bit and became progressively worse. The "Cancel" button would...
  14. S

    Kitchenaid Fridge Display Panel Acting up among other problems including ice in bottom of freezer

    I have a Kitchenaid KSRS25ILWH02 side by side fridge. About three months ago I came back from 2 weeks' vacation and everything in the fridge was frozen. We opened up the fridge door for an hour, then everything seemed to be ok. About a month later there was water on the floor. I could see...
  15. C

    Maytag dryer cones on but won't start

    The other day I was adjusting the mattress cover that was drying and when i put it back in and pushed start I heard a pop and it wouldn't start. It comes on, but won't start. My FIL took the lid off and immediately a control lock light came on. We were going to replace the thermal fuse, but...
  16. T

    whirlpool error E6 F2

    I have a Whirlpool double oven with an E6 F2 error code that randomly appears throughout the day, followed by a total display shutdown. Even when the display is off, the keys make the triple chime error tone when pressed. I know that this error code means that either the keypad or the control...

Support Our Site

If you feel that you have benefited from this site, and would like to show your appreciation, please consider making a donation.