diverter

Over the past 6 weeks, a local service tech has been servicing this 6 year old dishwasher as it was failing to fill with water at the beginning of a wash cycle. After changing the pump, a defective main control board and the flood switch (in that order) it finally seemed to be working. Thank...

Our KitchenAid dishwasher has another problem. It started leaking last night, diagnostic shows a 9-1 fault (diverter electronics?). I ran a test cycle and saw water dripping from the diverter, though I’ve seen from other threads that something else might be leaking. What is the best way to...

The lower spray arm of my dishwasher is not turning. I get plenty of water flow through the upper sprayers. I ran the diagnostic and got NO error codes. However, immediately after running it and carefully removing the sealing cap, the diverter disk was off the shaft. It was definitely on the...

Hello, I have a KDTE104ESS4 dishwasher. It does NOT seem to be washing as good as it should: 1. It has the strangest intermittent humming/throbbing sound. 2. I also detect that it is not emptying/rinsing that well sometimes. It smells a little like dried soap and the water left in the filter...

The dishwasher was not cleaning properly (the soap pod was not always dissolving) and I ran the diagnostic test and noticed a F7-1 code. I checked the resistance on the heating circuit and had continuity in the recommended range (I did not check the components individually). Reset the code and...

Our 1 and 1/2 year old dishwasher suddenly started leaking where the rubber hose is molder to the diverter. Is it possible to replace the diverter with a new one without removing the dishwasher? Or do I have to slide the dishwasher out and lean it back to replace it?

Model: GE GDT695SMJ0ES Symptom: Middle arm doesn't spin Detailed problem description: Work on this appliance started a week ago with a major leak coming from the bottom of the dishwasher. I found that the rubber hose on the diverter had failed. After replacing the diverter the top rack would...

I have a leak on a Kenmore Elite Dishwasher model 665.12793K311 which is only about one year old. The problem appears to be at the diverter motor (part#: W10380170) and its seal with the bottom of the sump (part#: W10457989). Internet research so far suggest a problem with the seal being...

Greetings, In 2010 we installed this dishwasher, and it generally worked fine. In 2013 the dishwasher started cleaning less well and the Sanitized LED would blink after a sani-rinse cycle. We had a tech out and he replaced the diverter motor, and things seemed to return to normal. Here we...