f51

Let’s start from the beginning. My Maytag Bravos needed the bearings and seal replaced, was throwing code f51 and leaking water under rotor and stator and sounded like a jet engine taking off. Had no other codes being thrown or any other problems. Anyway, got washer took apart and cleaned out...

Washer periodically over the past couple months would display the error code oL but unplugging the washer would reset it and it would operate properly for several days. Finally the unit quit mid normal cycle about 22 min left in the cycle. Couldn't use the service manual, it is missing, so...

Seems like this thing has begun dying piece by piece suddenly. We'd had no issues with this 9 year old washer before last May. In May I had to replace the user interface board. About a month later, in June-July, I had to replace the balance springs. Now about two months later something else...

I need some advice on fixing the F51 error code on my Cabrio washer. (Model WTW6600SW2). I have replaced the bearings and shaft (which needed to be replaced a while ago anyway), replaced the rotor position sensor, AND the stator. Still getting the F51 code! When I try to put it in automatic...

Hello all, sorry if I'm intruding or anything, I didn't know if this forum had a introduction section or not. I have a Whirlpool Cabrio (M# WTW6500WW1) that had the F51 error. I had tried the manual spin to see if the RPS's worked, and at first they did. All 3 lights lit up as I spun the tub...