maytag

Hi Appliance Blog Community, First off, I want to say THANK YOU! Honestly, I've been looking around for information about my Maytag MVWX655DW0 and after stumbling on this site I'm blown away by how helpful folks are. 🙏 I'm seeking help with my Maytag as it barely agitates, I have a video below...

I'm not sure the exact model number of this washer, the manual says MAV6250 * MAV6300 * MAV7200 * MAV7257 * MAV7258 My mom called me up to try and diagnose her washer. Symptoms are reported as a loud squeaking during certain parts of the cycle (which ones I'm not sure) and finding water on...

Looking for Maytag MIM1555YRS2 Service Manual. 2013 Model. Thanks

Hello! My ancient Maytag won't spin or drain. It fills with water just fine. I replaced the pump and drive belts, and it didn't fix it. Then I replaced the whole motor and still no dice. when I move the wheel attached to the motor by hand, it spins the drum and pump just fine. My next thought...

I have the replacement heating element but can find a manual or video on how to get the back panel off - maybe I am missing something? Thanks

So, I am completely LOST on what seems like it should be a simple problem, and I'm wondering if any of the experts here might be able to offer any advice. I have a Maytag MER5755QAW and I recently had an incident where the bake element went out in SPECTACULAR fashion- taking out about 6-7...

Maytag dishwasher suddenly stops working part way thru the cycle. Water still inside when this happens. This first happened 5 months ago. None of the buttons on control panel light up. Confirmed power is getting to control board. Breaker never tripped. Confirmed continuity on thermal fuse...

My Maytag refrigerator starting making a clicking noise this morning, like an on/off click, approximately every 5-10 seconds. With each click the control panel on the front would also go on/off. The interior refrigerator lights would stay on. Unplugging the unit for a few minutes did not...

I have a couple of older Maytag washers that use a rubber gasket to seal the door. I notice that there is a hole punched out on one of them and the same hole is not punched out on the other. Is it OK to have it punched out? Will it leak? Thanks Steve You can see the hole clearly in the...

I bought a used MLG2000AWW Neptune stack unit and it needs a new washer door seal. Wondering if anyone has a used one they'd like to sell? Trying not to spend another 125$ for one. Paid 200$ for the stack unit and everything works but the door seal is pretty bad. Thanks. Part Number...

My Maytag MVW7232HW0 is stuck on Add Garment - there are clothes in the washer, when I try to start a cycle, I get an 'Add Garment' message. I can then open and close the door, the washer indicates that I should press start again to start the cycle, but when I do press start again - Add Garment...

I've reached a point where I could use some help. My Maytag MHW6630HW0 will not spin. It will turn on and appear to start a cycle, but it will not spin the drum. When the cycle starts I hear a click like a lock is being released and then nothing. In my troubleshooting I removed the back panel...

Started taking apart this maytag to clean it up, and noticed a busted idle pulley lying on the ground! I'd like to replace the belt and pulley with something like the 959P3 kit, but I worry the same thing will happen again down the line. The motor mount in my washer has no cutout to...

Hi I have a Maytag Performa that's at least 10 years old. Last week, it started to make a squeaking noise and a burning smell. Today, It filled with water and stopped and the burning smell was very strong. Please help me identify the problem or should I go buy a new one?

So I had a power surge fry a Cap on the Jazz board of my fridge. I got it off but don't have the full label of the cap to know what to replace it with. Hoping that the hive mindof the internet can help me out.

MVWX655DW1 Maytag Bravos Washer. 2.5 years old. ISSUE: Making a squeaking or rubbing sound, demonstrated in video. VIDEO: ADD'L INFO: It sounds like dry rubber or plastic rubbing against something. It is cyclic / intermittent; only makes the sound at certain points of a revolution...

My washer control panel seems to be failing. Power/Cancel button doesn't work. I can turn the washer on by turning the dial. Yesterday, the cycle occasionally had the right minutes to it, and then displayed "6,5,4,3,2" and cycled through the numbers again or switched to another setting...

The timer will not advance, the wires don't appear to be in the correct location. Having an issue with wiring up the new upgraded timer... (2-4476N) OEM (204476)

Hi! I have a Maytag Centennial Washer MVWC300VW0 that makes a loud rubbing noise during spinning. It seems to be agitating, although maybe not moving as much as it used to (I'm not sure of this, but there is still some agitating). When it gets to the spin mode, though, the basin does not spin...

Hi, Newbie to Appliance Blog here... I've got one of the old Maytag MCE8000AYQ Drying Centers that stands about 6' high and has the delicates drying cube on the top with the screen racks and the hangers that shake back and forth. We have had it for about 17 years and love it so much that we...