maytag

Hello, I have an 8 year old Maytag Bravos washing machine (MVWB880BW0) and it recently starting making a loud noise during the spin cycle. The noise gets louder the faster it spins. Everything else works as it should and the machine still does a good job washing clothes. I've researched this...

This is a typical 2 belt, motor on left, single speed, drian pump on right model from 1993 based on SN. This is long, I've been at this a while, sorry. I'll bullet point this as best I can. Tub didn't drain, drain pump impeller didn't spin with pulley, replaced pump, also replaced belts. Tub...

My oven stopped working and the code said it was the control sensor. The repair person came out, but not even the clock was working on the oven. The repair person said to send the control board to be repaired since Maytag and others no longer carry the control boards. Now the light in the...

Maytag Atlantis washer. Agitator works: washes okay, but after rinse does not spin out excess water. Pump is functioning as water is removed from basket. When in Spin mode, I try to turn the drum/basket, but it is locked and frozen. In the past, I was able to rotate the drum endlesslessly...

Hello, I have a Maytag MDE4916AYA electric dryer about 15-20 years old that is in wonderful condition, except for that over the past 10 years, i've always felt that the DELICATES temp setting had no different temperature than the REGULAR temp setting. I never really did anything about it...

Washer is less than two years old. I feel like it’s been making this super loud noise during wash cycle or is this normal? I already have to have someone come out because an inlet or valve is leaking drops of water when it’s not running. Also the lid is super touchy to lock so it’s a lot of...

I have a Maytag MVWX655DW1 washer. It will get stuck at sensing mode and not move past that. It shows error code F8E1 on diagnostics. After the code is cleared it will run a load all the way through normally. Then it stops again at sensing and bad the code. It went through the auto Diag mode and...

Hello, I have a Maytag Refrigerator (Model MFC2062FEZ). Periodically there is a noise that comes from this area (presumable behind this shroud, see pic). I'm going to guess it's the evaporator fan here? How is this shroud supposed to be removed? Tried to pry, pull, slide, push, etc....can't get...

Both the freezer and refrigerator are set to 7 (max cold), and are cooling to between 9 and 15 deg (freezer) and 41-45 (refrigerator). I've done the following: Clean coils and fan by the compressor Checked the coils in the freezer......there was only minor frost on the lowermost portion...

My older maytag model MBB2256GEW is not cooling or freezing. When plugged in the lights and fan work fine, just doesn’t not get cold or frozen. I tried cleaning the coils, but not sure what to try and fix next. Any ideas are greatly appreciated. Thank you, Scott

Maytag LAT9416AAE washer - agitator shaft pops out Agitator shaft keeps popping out ..... I thought I replaced the collar that holds it in ......like 4 months ago...I did replace the collar - although the installation didn't seem like it really holds the agitator shaft in.. now the agitator is...

Alright so, I recently replaced a part, it was the thermister for this washer because it was getting water in the machine after the cycles were over leaving the clothing wet, Well... that worked, the replacement is great but now, the machine is just spinning forever in a cycle. Even in the...

I have a older Neptune Stack that the washer portion has stopped working. Ran a load last night and it finished normally. Put the load in the dryer and the dryer started just fine and is drying the clothes. Put a load in the washer and hit the start button and nothing. Usually the ON light...

I have a Maytag Neptune Dryer model number MDG5500AWW and it recently would not turn on; there are no lights on the control panel however, the light within the dryer is still on and turns off when the dryer switch is pushed. Does anyone have any ideas of what could possibly be going on?

Hi, Had what seems like a pump malfunction during a wash cycle and heard a scraping noise from an object under the inner tub basket. Checked the pump and there was no obstruction but saw a paper clip in the outer tub. Got the agitator removed but I'm not familiar and couldn't find any info on...

I am missing a baffle screw. I took the screw in to a hardware store to figure out the size and threads. It doesn't seem to fit in anything. The closest was 8mm and something similar in Standard size. The part number I found is 33002973 but I can't find any onlline. Can anybody help on what...

Hi all, I hope everyone is staying safe during this time. Go figure now is when we start to have problems with our washer. Our washer will fill, stop then drain without advancing into the wash cycle. I entered diagnostic mode at first there were no error codes. I ran the auto sequence, all...

Hi, our small condo complex has a 6 button maytag coin-op commercial washer,model MAT23PCAAW Hardly anyone uses it so its hard to maybe get someone to own up if they broke it, but, is there a way to reset this machine? We approached it and it had the coin amount displayed but tub was full of...

I have a maytag bravos dryer that was not heating. We replaced Cycling Thermostat and it worked fine for a couple of days. Now its not drying again. We have checked the thermostat, hi and low fuses, heating element and all are getting continuity. Even confirmed that the heating element is...

Hello all: I have an older Amana Electric Wall Oven "Model AO-24SB". Manufacture # P85567-1S. Probably 30 years old. Some places it's called a "Maytag AO-24SB" model. The lower baking element will only be warm (not a hot red glow) when the oven in on bake. The upper broiler element...