mcu

I decided to make a new thread for this instead of go off topic on that thread. This Saturday, I came to my machine with my towels still pretty soaking wet. I put the dial in spin/drain and pressed the button, but it never went into spin mode, drain pump was going strong. I uplugged the...

My Kenmore HE2 Plus is currently not working properly. I've taken it apart and done the diagnostics and everything. The front ground switch was broken, so I just cut it and grounded it directly. That doesn't seem to have solved anything, though. When the diag runs, the drum turns at a couple of...

My washer gave the family a Christmas present this year. It stopped working on Christmas eve. I did some googling and troubleshooting yesterday and I just need some confirmation that I'm heading in the right direction. The last four error codes in memory were F01 E02, F04 E00, F01 E02, F04...

Please help! My machine allows me do choose wash type, options, soil level, etc. I can choose any cycle I desire, but when I hit the start button for a second, the door locks, the detergent holder fills with water, the drum fills with water and just when it should start turning, the timer...

Hello, My whirlpool duet ht washer, GHW9200LW, recently began malfunctioning. It started with showing an F06 code and not completing any cycle. I troubleshooted a couple things and finally decided to spend the $170 for a new MCU unit. After I installed that it didn't fix the issue, except, it...

Hi, Here is a little back story leading up to the issue at hand. My Kenmore washer (model: 110.44921.300) is a little over 10 years old. We have had zero issues with the washer up until this past month. This past month we had an issue with the drum not spinning at all. After reading the...

I have a 10 year old Whirlpool Duet front loading washer. It has an error code of F11. Replaced the CCU and the Door Lock mechanism. Still has F11 error code. I have had the MCU out of the machine freshened up the contacts on the board and put it back in and still having the error code...

By reading these excellent forums, I decided I could tackle the repair of my front loading Duet. So far I've done this: Ran diagnostic test. It only got to C:01 I cleaned out the pump filter next, had to buy a metric star bit set, remember to pull the plug, took off the lower front cover of...

My 3 years old washer started displaying the F6 E1 error after I replaced the fill hose (major leak dripping down the bottom plate, but the error didn't appear until after I replaced the hose). I could cancel and restart the wash but with the same result. Once it displayed the F1E2 error, but...

All, I've identified the source of my nasty F11 error, two components on the PCB of the MCU have had their connectors rust away to nothingness. I'm willing to take a shot at resoldering them, but the darn board is stuck in it's plastic housing. I've removed 4 screws, and even the screws from...

Our HE3t as started throwing the F11 code a lot more frequently. I looked at the wiring and the wiring connections which seem to be fine. I know from the research I have done that it boils down to CCU or MCU and out the two it seems that the CCU is the more frequent part to be replaced. One...

I was wondering if I could get some feedback from people about their experiences with their whirlpool duet washers and the infamous F11 error code. Seems like this error code has been happening to a lot of people with fairly new, just out of warranty washers. Please provide some details of your...