no heat

Recently dryer stopped heating up. Checked voltage incoming and measured at 120V both legs, 240V across. Replaced cycling thermostat (WE04X25200) and outlet control thermistor (WE4M448) but still no luck. Still getting fault codes 1, 2, 9, 10. Planning to order the inlet control thermostat...

Hi everyone! I have the following stove that the lower oven stopped igniting. I took it apart and turned the oven on and the igniter doesn't glow at all. I think it might be the igniter. GE Model: PGB960SEJSS I found the following igniter available for the stove at an online GE parts store...

This is an old dryer - a good twenty years, I'd guess, if not a tad more. But I hate to get rid of it, as it's easy to work on and just WORKS. Earlier this week, we discovered that it wasn't shutting off - it would run to the end of a cycle (timed dry or auto) but run indefinitely in the "cool...

I'm experiencing issues with the thermal cut off fuse blowing off after a drying a couple of loads. I really am running out of ideas as to what to try next with this dryer and would welcome advice. In the mean time, this is something I noticed and didn't pay much attention at first but will...

Kenmore Dryer 110.97272100 Tested for Continuity: Thermal Fuse High Limit Thermostat Cycling Thermostat Timer Igniter Still Needs tested: Gas Valve Solenoid? Flame Sensor? My Kenmore Dryer (Model #110.97272100) will not heat and the timer will not progress in automatic mode. When in timed...

I set the dishwasher to do full "Pots & Pans" cycle with "Sanitize" option selected. The dishwasher goes through full cycle, but dishes aren't cleaned well, and they aren't dry. Also, when cycle is finished the "Clean" indicator light is on, but the "Sanitized" indicator light is not on. I...

Hello. We moved into a new home 7 months ago and have been having problems with this gas dryer ever since. I am not sure how old the dryer is, but assume it is less than five years old. The dryer normally does not have heat and takes multiple cycles to dry, though occasionally and inexplicably...

Alright, I've been shooting in the dark here and am at about the end of my knowledge/what I've found through researching. I've "inherited" (found near my apartment's dumpster, I needed a dryer and I'm decently mechanically inclined so I figured I'd give this a go at fixing) a Kenmore Elite...

I am having an issue identifying what is wrong with my Kenmore Range. The model no. is 79073433314. The other day I went to turn on my oven to preheat and there is no heat or sound that there is gas being sent to the oven. I do have propane...first thing I checked, but I am struggling to...

Hi I have a LG Dryer DLEX3570W which is about 6 years old I am having issues with error code d80, d90, d95 and the dryer shutting off earlier and leaving clothes wet/damp. Below are the steps taken so far and really confused on what else I should test. - cleaned the ductwork and checked...

About a year ago the dryer would cycle on and off too quickly for anything to get hot enough to dry clothes. I tested continuity on the fuses and ended up replacing a bad thermostat and a bad hi-limit. Been working fine since. Today, it stopped heating completely. It runs fine, but the heating...

Hi - I have Kenmore Elite Dryer He3 Model 110.82822100. I have no heat. I have done the following: 1. Checked heating element -- reads 10 ohms 2, Checked Over temp and cutoff on heating assy. ; Both test good (0 ohms) 3. Checked all three in series - reads 10 ohms 4, Checked thermal fuse on...

Recently purchased a used Thermador SC302T(S) Oven ("works great"... :-( ), and when I connected it to power to test it, the display powered up and the buttons respond as expected. I can hear a fan begin running when I select either upper or lower bake, or upper or lower broil. The display...

Hello Here is the Kenmore dryer with a sensor control panel. It runs, but not heating. The weird thing is that it has F4E3 (restricted airflow) and F2E1 (stuck button on the control panel) error codes while the only problem that really exists is no heat. The igniter starts to glow, but then...

Hi Everyone - Thanks in advance for your help. My Kenmore Countertop microwave and pizza oven, Model 721.66993800, recently stopped heating and the turntable stopped turning. Everything else *seems* to work: Lights, touch panel, fan, and the pizza drawer heating element. I can set the cook...

Hi, This stove is about 12 years old and we are the original owners. The over stopped working a week ago. No noise when selecting 'bake', 'broil', etc. Gas line is good: stove top burners work fine. Electricity is good: digital clock is working There is no clicking sound or 'whoosh' sound...

Anyone familiar with repairing gas dryers? The problem is the dryer will not heat anymore. So i figured a lint build up was triggering it not to heat. I took the front and back of the dryer apart to clean out all the lint. Including lint trap and exhaust fan. The problem is not the lint. The...

This unit is my elderly parents dryer (isolated due to COVID). I have only worked on electric dryers. I may try to visit today to look at it and troubleshoot, but I was hoping for some ideas on what to look at first. This unit is 20 yrs old and they want to replace it, but Mom won't buy on line...

My kenmore dryer has no heat

Hi, The range above stopped working all at the same time. The surface elements and the oven do not heat anymore. I can turn the surface elements knobs and it says it’s heating, but no heat on any of the burners. The oven also has no heat and the oven knob just clicks when I turn it on...