pump

  1. W

    FIXED Kenmore stand alone ice maker 106.89592100 pump issues

    To start the ice maker was making to much ice, we shut it off for a few days then more issues developed. when we turned it back on it would not pump water to the freeze plate. I replaced the following parts Remanufactured control board, low voltage transformer, ice bin temp sensor and ice maker...
  2. K

    FIXED GE Washer WCVH6400J0WW - won't run through cycles properly, error code 54

    Trying to help my mom fix her washer, front loader, model # in title. She called me up saying it wouldn't fill with water. The symptoms I observed are when attempting to start any cycle: the door locks, it makes a couple of faint clicks, then it sounds like the drain pump runs for a few...
  3. D

    LFSS2612TE0 Frigidaire Refrigerator water dispenser not working

    The voltage at the main pump was only 86V when water dispenser flap was pressed. The water dispensing pump received 120V though... Thanks for your help!
  4. T

    GE Washer Replaced Drain Pump WH23X24178 twice in last six weeks.

    I replaced the drain pump 7 weeks ago. The first pump lasted one week. Thinking it was a bad pump I ordered another one and replaced it and it now has lasted six weeks and will not drain. I am using the Original GE Pump for my model. Is there anything wlse that could be causing the pumps to...
  5. T

    KUDS25SHWH1 new pump and motor, lower spray arm binding (frustrated)

    Hi everyone ... this is my first post. After I replaced the motor and pump assembly on my KitchenAid Superba Whisper Quiet Ultima Dishwasher model KUDS25SHWH1 that stopped the leak, but I finally noticed the bottom spray arm is striking the bottom of the lower rack. In fact, I don't think the...
  6. P

    FIXED 665.13749K603 Kenmore dishwasher intermittent drain

    Hi there. I love this site!! I have a Kenmore 665.13749K603 that has draining problems in and after a cycle, leaving dirty dishwater in the machine even though it says 'clean'. But I can use the cancel/drain to get it to drain after the cycle is all over. Though it may seem old, since I got...
  7. J

    Whirlpool duet sport WFW8300SW01 - Pump failing? - F01 code

    Hi, thanks for this informative blog! Yesterday my machine stopped during rinse cycle and displayed F01 error code. There was still water in tub. I pressed cancel button twice, then unplugged, waited one minute, replugged in power and pressed start. The front panel was already off, so I easily...
  8. V

    WFW72HEDW0 Whirpool Duet pump issue?

    Hi All! So, a few days ago, I started getting the E1 F9 Error, draining too slowly on my Whirlpool Duet WFW72HEDW0. I removed the drain plug and cleaned it thoroughly, I also removed the drain hose running up the side of the machine and cleaned it along with the exterior drain hose. I...
  9. C

    WT1101CW OE error at end of cycle

    Please read for full context, admin closed other thread since my issue was slightly different than the one I joined. Started new thread. TLDR: pump functions fine during regular cycle, and then sometime at the end of a rinse and start of spin cycle, the pump runs for literally one second, then...
  10. P

    FIXED Asko T700 Dryer Drain Pump connectors

    Hello, I am replacing the drain pump of my dryer asko t700. It has two plugs plus the ground, but I don’t remember which one goes where ( I know where the ground goes)... the cables are both black and there is no other indication. Can you help me? Thanks!!! Danielle
  11. J

    665.13542 Kenmore circulation pump very inconsistent on starting

    I'm about to lose my mind with this. Cannot for the life of me troubleshoot it! About 2 months ago, our Kenmore Elite, at 14 months of age, started operating very inconsistently. We start a cycle, and the drain pump activates and works, then the hot water fills, then about 50% of the time it...
  12. A

    FIXED Leak in Maytag Atlantis MAV7600

    I have a leak in our Maytag Atlantis MAV7600. I thought it may be from one of the hoses but when I took off the front they look fine and so do the clamps. I ran a rinse cycle with the panel off to see if I could see where the water is coming from and couldn't see any. I had noticed last evening...
  13. J

    Sub Zero 3151 is making buzzing sound - possibly the pump

    I have an older Sub Zero 3151 (made by Scotsman) under counter ice maker. There was a little mold near the water jets so I sprayed it with some 409. It started making a buzzing noise immediately. I then flushed it with cups of clean water and the buzzing went away, but only for a few seconds...
  14. J

    CDT765SSF0SS GE dishwasher - drain pump runs dry

    Hello All - My dishwasher has been working strange recently. I noticed that throughout the cycles, the dishwasher will fill with water/wash and when its time to drain it will drain all the water and continue to run dry with no water left in the sump. It runs for a good 5 minutes dry with no...
  15. S

    665.77973K703 Kenmore Elite - Circulation Pump Motor Parts

    Hello, The washer motor in my Kenmore elite packed it in suddenly with little warning. After disassembling the circulation motor I discover that 3 of the 6 magnets had started to rust, causing the plastic housing to swell slightly. This "swelling" stopped the armature from turning, requiring...
  16. M

    GDT545PSJ0SS GE Dishwasher not draining

    Hello, my GE dishwasher has stopped draining. I've had it out, disconnected the drain line at the pump and it pushes water through hose if I blow through. Empties into disposal fine. If I start a cycle, let it run and then cancel the cycle I do not hear the pump running to push out the water...
  17. P

    Problem with WDT720PADM -- bizarre wash cycle

    We own a Whirlpool WDT720PADM. Suddenly it is behaving rather strangely. 1) We start a cycle 2) It drains, which is normal 3) Water trickles in, which is normal 4) It stops doing anything. No washing happens. 5) But the clock keeps counting down. 6) At intervals which are normal to the...
  18. N

    FIXED How to remove inspect clean/replace pressure sensor in FPID2497RF frigidaire dishwasher??

    been browsing this forum, and it seems the frigidaire dishwasher pressure sensor is a lemon, how do i remove it? --------------------------------------------------------------------------------------------------------------:sulkiness::excitement::disgust: hello i have a frigidaire professional...
  19. C

    110.42832200 Not your typical F02 problem

    Hey Everyone... Kenmore 110.42832200 Hoping to get some feedback on an issue I am having with my Kenmore HE3 front load washer. The initial symptoms related to the ever famous F02 error code. Well, after confirming that the hoses from the drums to the pump, from the pump to the back to the...
  20. H

    SHE3AR56UC Bosch Ascenta dishwasher won't drain or start cycle.

    Had several problems with this thing, and most of the time the problem just magically fixes itself. But now, at the end of cycle yesterday it hadn't drained completely. Restarted, nothing. Cleaned filter, checked impeller, nothing. It will not start a new cycle, sounds like the pump doesn't want...
Top