rotor

I took off my rotor to look for water that was leaking. It was not leaking through the seals behind the motor. However, when I put the rotor back on and run the machine it will not go through a cycle. The rotor makes a noise but it will not engage and spin the drum, the cycle does not progress...

Hello everyone, I need help determining which part I should replace. I have a Whirlpool Duet Washer (WFW70HEBW0) that makes a terrible noise during the spin cycle. It still works fine, but it sounds like the washer is going to go through the wall! I attached a link to an audio clip so you can...

My washer was making a rocket launching sound, so I replaced the spider, bearings, tub seal, and shock absorbers. On my first wash cycle, everything sounded great until the final spins. I heard a grinding sounds then smelled something burning. Upon inspection, I found that 2 magnets in the...

Hi, I'm hoping I could get some help here. I have a Samsung front load washing machine and last night at the end of a load we heard a loud bang and the washing machine was just completing a load. Upon opening the door, I could smell a faint, but noticeable smell like burnt plastic or something...

Hi All - Appreciate the help with improving my mechanical skills! First some background info, In the beginning, I gathered up at least 2 spare Cabrio WTW6600SW1 washers as they were unfixable for many, and they were selling them for either nothing or like $50. I stripped one and kept one in...

Everything was going smoothly. Used the recommended bearing press tool to install the bearings. I installed the new drive shaft. Used a hammer and block of wood to ensure the drive shaft bottomed out on the top bearing. Instructions said to "tap" with hammer. It required a few strokes a bit...

Whirlpool Cabrio Washer First, F54 Now F50, F51 and F72. Bearings replaced last month. In May I got tired of my Whirlpool Cabrio throwing constant UL errors during the spin cycle so I sent away for a new bearing kit and repair tool. I repaired the unit successfully on June 1 and it ran well...

Hello all, sorry if I'm intruding or anything, I didn't know if this forum had a introduction section or not. I have a Whirlpool Cabrio (M# WTW6500WW1) that had the F51 error. I had tried the manual spin to see if the RPS's worked, and at first they did. All 3 lights lit up as I spun the tub...