shaft

  1. J

    Whirlpool Cabrio Shaft/ Bearing Replacement

    Hello Experts, I am out of options. I am on day two of this project and have one last hurdle I cannot figure out. As far as the youtube videos go i have done everything correctly. HOWEVER, when put the basket back in and try to install the "drive nuts" between the shaft and basket there is about...
  2. H

    FIXED WSM2700TDWWB GE Stack Washer - Stripped Shaft Threads?

    Since I replaced the agitator drive hub* a few months ago, the plastic cap that screws onto the top of the agitator kept coming loose. It got to the point that it unscrewed after a single load. Well today I couldn't screw it back in. I took the agitator out, and it seems like there aren't any...
  3. B

    FIXED SCD23VBW Evaporator fan blade loose

    The evaporator fan went bad (it was humming when I accessed the compartment and would spin briefly if I flicked the blade but would seize up again). The fan blade was held to the shaft just by how tightly it fit the shaft. I have just received the replacement fan motor which says it is a...
  4. G

    FIXED LG WT5001CW Spline on new clutch is the wrong size

    I ordered a new wash plate a few years ago and it fit fine. I had to replace the clutch assy. recently. Ordered the part and installed. It started the UE code so I figured the splines was stripped again (common problem) When I removed the wash plate, I discovered the spline on the new clutch was...
  5. R

    HTWP1400FWW Hotpoint washer won't agitate; occasionally spins; leaks??

    Hi, I have a Hotpoint washer, almost two years old. Used pretty heavily. It won't agitate (squeaks like an injured dog), only spins when it feels like it, and there's water underneath the drum, leaking onto the floor. I took the laundry out, took the front cover off, and ran it (empty) on the...
  6. B

    Metal washer on Samsung spider

    I received a new spider for my Samsung front-load washer. Like the original, it comes with an O-ring on the shaft, perhaps to cushion vibration where it rests against the inner bearing. The original also had a thin, razor-sharp steel tapered washer riding on the O-ring, sandwiched between the...
  7. B

    Maytag LSE7806ACE drum roller shaft not matching new roller

    I'm just wondering if anyone else has seen this scenario and if so, if you have advice: My dryer was squealing, so I ordered new drum rollers, belt and pulley. When I got the drum out, I could see the right roller was crusty, loose on the shaft and squeaking when I rolled it around. Easy, right...
  8. J

    Maytag Dryer- Pulley on motor shaft striped.

    The Pulley that goes on the motor shaft striped out. It looks like the threads on the motor shaft are ok. The pulley threads are gone. The pulley is silver and on one side has a hex area to wrench it tight. I couldn't find the pulley on repair clinic. Can someone post a link to the correct...
  9. R

    FIXED Unusual Whirlpool icemaker dispensing failure

    The ice maker on my two-year-old Whirlpool side-by-side stopped dispensing ice. The ice container was full but the motor sounded like straining or stalling. I thought the mechanism was being jammed by frozen ice, and my first step was to remove the ice container from the door. Unfortunately I...
Top