shifter

  1. L

    FIXED Cabrio Top-Load (WTW8500DC2) Shifter Failure

    Lid locks, bucket slowly turns, doesn't fill and shuts down. The agitator did not move freely. Error code F7E5. Cleared and ran diagnostics, everything worked well except the spinning/agitation. Voltages checked out. Replaced the drive assembly. Ran the calibration, and same error now. What can...
  2. tmvhx9

    CAW9244XQ2 Crosley Washer Shifter switch wiring harness

    Washing machine started making loud noises during spin cycles (likely due to heavy quilt). Now the washer isn’t spinning or agitating. I followed the tech sheet and ran through things in manual mode. For agitation and spin, the motor hums, but nothing happens. The belt is intact and I followed...
  3. V

    110.28132411 Kenmore washer Won't fill and F7 E5 code.

    Greetings all I have a Kenmore 700 series washer that I have had for 2 years. Push start, the door latch engages, the washer starts the load sensing process (both drum and agitator turn), the washer goes to wash cycle (wash light comes on), then the machine goes to load complete with no wash...
  4. A

    FIXED MVWC360AW0 Maytag centennial won't spin; Diagnosis help

    Thanks in advance for any help I can get to clarify whats going on. I've done my best to figure this out, but I really want a double check on things before I dump more bread into this thing. In particular, my nagging question is that it wasn't throwing error codes until pretty far on into the...
  5. H

    NTW4600YQ0 Lid Lock LED Flashing at prewash start

    Hi all. I'm a new member of the forum and hope to get my washer working again. Here's the problem: After loading the tub and selecting load size, water temperature and wash cycle, I press start, valve solenoids begin flow of water for a few seconds, lid locks, I hear the shifter move but then...
  6. D

    MVWC200XW2 Stalling during the spin cycle and the lid lock light would keep flashing

    Maytag Washing Machine Model MVWC200XW2 Parts Hey All, Recently my Maytag Centennial started stalling during the spin cycle and the lid lock light would keep flashing. I put it in manual test mode and it passed ALL of the tests except the high and low spin. It had the following fault...
  7. R

    Motor wont run.

    GE hydrowave. just bought it for $20 with a motor problem. motor flash code 6. checked the shifter, sits at about 64 Ohms. the inverter board also makes about 8 high pitched beeps and i hear a relay click. did the lid dance twice. motor goes into standby, then into normal operation for about 5...
Top