Hello, I am trying to identify the correct part number or substitute part numbers for a 1956 GE Wall Oven, model 1J501M.
When I look at the existing thermostat it shows a number on the back side only, 281D857G 9. (Pic attached) Is this it? Seems very different from all thermostats I have...
I have a viking 8 burner oven. The right oven knob snapped off, making us have to purchase a new oven thermostat. Now I've gotten to the bones of the oven, and i'm comparing the two thermostats. It appears the one I have is slightly different than the original. But i'm pretty sure it will work...
Freezer icing up...assume that means the Defroster not cycling on, which would typically be a Defrost Thermostat. This model does not have a Defrost Thermostat but instead has a Thermistor, which says 'not serviceable'. Fridge is only about 2 years old. Anyone know what the Thermistor part is...
Hello,
Is there any schematic on instructions to be able to test a PW240028 thermostat. I have just replaced this thermostat (new) and frig is still having the same issue. Before I buy another thermostat is there a way to test these units. Issue keeps pointing back to it, but just find it hard...
Whirlpool Refrigerator ET18DKXAW10, ~30 years old.
A month ago I caught my fridge stuck in a short-cycling agony: ON for 5 sec and then OFF for 1 sec. The compressor was not starting on each ON cycle but that is expected as it has a thermal protection. When it did start it started normally. I...
im currently in the middle of my first ever appliance repair on my older kenmore (not sure the year) after it stopped heating up.
turns out that the thermal cut off and the heating element were both shot so I’ve gone ahead and put in a new element and smacked the cut off back into place.
now...
Kenmore Dryer 110.96586400
Dryer is about 15yrs old (I think) and the heat stopped working. Ordered the usual replacement parts
Heating element
Cycling Thermostat (4 prong)
High limit thermostat (2 prong)
Thermal fuse (long and narrow, 2 prong)
Thermal fuse (short and round, 2 prong)
The high...
Hello, I have a 1970's Hardwick oven that had the thermostat bulb break off. I've been looking for replacements, but have been unable to find the exact model number of my thermostat. The current thermostat is a 6061N0017B and I was wondering if I could use a similar model. It seems that I may be...
Hello, I have a whirlpool beverage center that started making the clicking noise. After researching decided to replace the relay and overload JPQII-4.7 and BT68-135. In this system (picture attached) there is a red wire (120v thermostat wire?) going into the overload, 2 white wires connected to...
Hello all,
I have a customer with a refurbished Samsung DV350AER who initially phoned me about an excessive noise. I had replaced the rollers in it as they had failed and that problem has resolved. A few days after replacing the rollers, customer phoned me back to say that the heat had stopped...
Been working on our 1950's RCA Estate Range/oven. The oven fluctuates in temperature - set it at 350 and it will vary from 250 to 450. Removed the thermostat and took the Thermocouple out of the oven box. The Thermostat appears to be working okay, when I put a multimeter on it. The...
So I’m trying to replace a thermostat in my haier 2 compartment mini fridge.
getting the thermostat/probe out was easy enough, but I didn’t pay quite enough attention to where it came out, exactly. It used the same hole in the plastic internal lining As the power cable. it just slid out as I...
Hi, im trying to get the thermostat and heating elements for my wall ovens but the plate is gone with the model info :-(. i had taken it down before and think it was (model c2501av / 910 /serial scd35293 / outside 25.5' square inside 21x15" element 236 volts 3000 watts wb44x126) but the...
My Kitchenaid 25 cu ft 36-width French Door Refrigerator is ( Kitchenaid Model Hyperlink ) Model KRFF305ESS. Recently the GFCI started to trip whenever the defrost mode was utilized. I replaced the GFCI, which was old, but the same issue persists. If I plug it in to a non-GFCI using an...
Hay everyone I've got a 1980's
Hotpoint model:WS820H-1
Serial # AA 151430
Wall oven with a burned out thermostat assembly and am hunting for a replacement. Oven has self clean function and food temp probe.
Hello from Denver, Thank you in advance for considering my questions. In my quest to determine if my defrost timer is working properly I put a red ink mark on the gray part that you can insert a flat head screwdriver into for manually moving the timer into or out-of defrost mode. Picture below...
I am sorry if this is a very vague, newbie question. I am looking to replace our old thermostat. The thermostat is only being used for the furnace (we have no central air). Unfortunately I do not know the furnace model, only that it's a Burnham oil furnace. I have included some photos of the...
Hello! I have an old stacked washer dryer set Kenmore 417.89390600. (new to me). It all seems to work but drying time seems slow. I've blown and vacuumed lint trap area and likewise along with rotary brush cleaned out exhaust hose. Heating element has continuity and measures 22 ohms. - I suppose...
GE PROFILE PGB995DET1WW double oven -Top oven stopped working. Replaced the igniter glow bar - WB13X25263 because the old one was broken, but the new igniter does not get hot or glow at all. Resistance measured at 108 ohms, but the wires that plug into the igniter are only getting 12 volts when...
Thermostat Post
Hi everyone, I bought an old chest freezer that I want to adjust to use as a fridge. I am aware that freezer thermostats generally have a screw that can be adjusted to change the temperature range, and that many also have a "differential screw" (there may be other terms for it...