whirlpool duet

The other day my whirlpool duet would not start.you press start, it counts down as if it's running but no motor or blower. I could hear the motor power relay click. A month ago I had almost this same problem, that I fixed by soldering a new motor relay on the control board. I thought for sure...

I have an older (I bought it used 3-4 years ago) Whirlpool Duet dryer that started making a rumbling noise when it is on the drying cycle. Admittedly, it started off not too bad and I have been procrastinating and now it sounds like a jet engine whenever the dryer is running. It doesn't really...

I have a Whirlpool Duet dryer, mod# WED8300SW2. It continuously runs with no heat and the panel lights are off. I open the door, it stops running but then I close the door and it runs...no heat...panel lights off. Any suggestions?

I’ve got a 3 - 4 y/o whirlpool duet steam washer. Mid washing cycle heard a noise like a nut came off and hit some metal. Then I got the error code. Turned it off and now it won’t sense any clothing in the drum. Shows add garment light all the time. I am trying to find the service manual on this...

I have a Whirlpool Duet WFW70HEBW2 which is shutting off randomly mid-cycle - some times at the start, some times near the end. It does completely very rarely. It will stop the cycle, flash the door lock light, and drain the tub. Once drained, the door will unlock and the washer will shut off...

Hi Jake, I am new to the forum. I have a Whirlpool Duet washer model GHW9100LW2, 12 years old. Inner tub has rubbed against the front outer tub creating large amounts of shredded plastic from the front tub. Your forum helped me tremendously in determining the issue-thank you. Whirlpool replaced...

I have had problems with my Whirlpool Duet washer making clunking noises during spin; searched your forums and found this thread: FIXED Whirlpool Duet Broken Spider Arm with Jyn from Feb. 20th, 2012 which diagnosed a broken spider arm. She also advised that the spider arm comes assembled to the...

Recently I started getting an F8E1 error message. I've disconnected and cleaned the hoses and blew compressed air in the back of the machine to clear any possible debris out of the intake connections; still I get the error message. While watching the machine it actually seems as though it might...

My Whirlpool Duet (Steam) front loading washer stopped running part way through a normal cycle and exhibited an error code. My wife tried to get the machine to run again and the code disappeared when she pushed the buttons so I manually released the door lock, removed the clothes, then ran a...

Hello, I've been sifting through some great resources on this forum, but find myself stumped with determining my fault code. Here's what I know... Brand: Whirlpool Model: Duet Steam Pant Number: WED/WGD 9750W*0 Description of issue: The Dryer appears to have power, as the information cluster...

I've verified that the washer is level, but it still shakes a bit - not enough to "walk" anywhere, but I don't want to damage it. Should I be concerned?

Recently (2 weeks ago) replaced the dryer vent duct because it was full of lint - thoroughly cleaned the lint from the dryer. Today we went to use the dryer and there is no power at all - no light on inside even. Checked the outlet, breaker, etc. and that is fine - another appliance works in it...

This all started with a leak. My washer was leaking a lot of water so someone suggested I check my door seal. Sure enough there were cuts in the bellow so I ordered a new one and fixed that. Not even a day after replacing that the belt to my motor broke. I ordered the belt and replaced that. My...

My Whirlpool duet electric dryer has 3 lights that are dim, "damp" "bulky" and "extra low". I cannot get into diagnostic mode and I can change nothing after pressing any buttons or turning dial has no effect. Drum light comes on when door is open. Thanks! David

Hi, I have a whirlpool duet electric dryer, purchased new in 2002; model #GEW9200LW0. It has always had light use, as we line dry and have another W/D set that we use in the garage, but yesterday we dried a few loads of clothes. When I went to turn the unit on today for short cycle to finish the...

Hi, My washing machine is leaking. I first noticed a bit of water on the floor of the right side of the washer, it looked like it was coming from the back of the machine, there wasn't any water in the pedestal drawer, so I thought maybe it was the hook up hose. I haven't pulled it out from the...

I had a technician check it out and he recommended replacing the control board so I replaced it with one purchased from appliancepartspros.com. The dryer came on after installing the new board but when I finished putting the dryer back the together and plugged it back in, nothing - just the...

I have a 10 year old Whirlpool Duet front loading washer. It has an error code of F11. Replaced the CCU and the Door Lock mechanism. Still has F11 error code. I have had the MCU out of the machine freshened up the contacts on the board and put it back in and still having the error code...

Hi all, I am getting the dreaded f11 error code. The error occurs when the spin slows to an almost stop (6min) mark. The clothes are relatively dry, no standing water and everything seems fine otherwise. I ran diagnostics and they all checked out fine. I took apart the MCU board and still have...

I am having a problem with my Whirlpool Duet. I bought it used from a friend and he informed me that he had to replace the drive pulley and belt as his wife overloaded the washer and they broke. I just had to replace the belt myself. My wife is not overloading the washer on the advice of my...