won't spin

We had issues with our washer not spinning before. Cleaning out the filter on the bottom left usually helped get it started again, but this time around it hadn't worked. We were initially getting the 3E2 error code which indicated it was the Drive Motor Stator and Rotor Assembly DC31-00112A...

Washed a load of clothes, everything was fine. A few days later tried to wash another load, machine made it to the drain / spin cycle but wouldn't drain or spin. Pulled Code from machine and it gave me F5 / E1. Door switch fault. Replaced the Switch, now it shows F0 / E0 which is no errors...

Hello, My top load Amana NTW4650YQ0 washer is not spinning during the Final Spin section of the cycle, leaving very wet clothes, when the washer is set to Regular or Casual (probably others as well). However, it does properly spin and dry clothes when set to the Drain/Spin cycle. In Drain/Spin...

Hello! My ancient Maytag won't spin or drain. It fills with water just fine. I replaced the pump and drive belts, and it didn't fix it. Then I replaced the whole motor and still no dice. when I move the wheel attached to the motor by hand, it spins the drum and pump just fine. My next thought...

Hi all, Did a search for this model and didn't come up with anything that matched our current issue with our GE GTW460ASJ4WW washer. We took a power surge from nearby lightning the other day and our washer has been acting up since. It powers on and will fill properly, it then will begin to...

My washer is currently having problems on the spin cycle. I have been going through the steps in the technician service manual. What is happening is when I run the spin cycle it will spool up and within a few seconds of that will stop and the lid lock light will be flashing. I have ran the...

This washer was inherited with the home so not sure of age but looks to be in good condition. When I first re-installed it a few months ago it ran well. Then it stopped spinning every time. I lowered the load size and it would spin on light loads consistently but that has progressively become...

We have a Maytag Bravos model # MVWB700VQ0. The spin cycle wont work after the wash cycle, it just agitates slowly back and forth but wont spin. It will eventually show a sd code and have flashing lights around the dial. I have taken the washer apart including the tub and cleaned out any...

After looking online to see why the washer won't spin, I figured I needed to replace the belt and splutch. When I got in there and got the stuff out, the belt looked OK but oil seems to have leaked over the parts; the belt cover was particularly coated. This seems to indicate something more...

I have a Frigidaire Affinity Model ATF6000ES1 On any cycle the tub slowly makes one turn and then stops, it does it again every 1 minute. I changed the Motor Control board; I cleaned the coins collector, I checked the Door latched. I have another motor on stand by; I hope someone is already...

My GE top load washer won't agitate or spin. I defeated the lid switch by putting the two wires together with a wire nut. This did not help. The washer goes through all the steps ending at the spin - but it is not actually agitating or spinning when it should be. The drive belt is connected...

I have a Frigidaire Gallery Series front load washer model number GLTF1240AS0. My washer recently stopped spinning at all and leaves my clothes soaking wet. I tried to reset it and that did not solve the problem. When it goes to start the spin cycle the drum just moves a few inches and stops. I...

One day, as the Mrs and I were upstairs we heard a high pitch squeal (for a minute or so) from the washer in the basement. Thinking it was a unbalanced load, the Mrs went down to check. She didn't see it out of balance so I came over. I could smell something was burning. Thinking it was a belt...

I got this washer and drier set free from a moving neighbor. Washer LSB6500PW0 and drier. He said the washer spins slowly, and takes two or three cycles to get the clothes less wet for the drier. How old is this thing? sn CR2705345 I have read on here that it is probably the clutch and...

Hello there! I'm trying to help my sister with a Roper washer issue. The washer will fill, agitate, drain and rinse without issue. It will not spin. After searching the net for solutions, I tried replacing the clutch. After replacement, the washer would only spin if she lifted the lid...

Hello, all! I’m very new here, so please redirect me if I’m posting in the wrong place. I have a Kenmore 80 Series top-loading washer built around 2002 as I’ve gleaned from the “M” in the second place of the serial number, based on an online search. Bought it used, six years ago and have...

Maytag Performa PAVT910AWW Won't Agitate or Spin and just makes a buzzing noise. I laid it almost flat on it's back but a little tilted upward to check the belt, etc. then decided to try the spin cyle and it start spinning normally. I tipped it back up to standing position and it continued to...

Hello Appliance People! I have a Maytag Performa Washer PAVT234AWW that will not spin so the clothes are soaked at the end of the cycle. Here are the things I have checked so far: Lid switch is working. Washer still agitates. It makes a normal noise in going through the spin cycle but the...

This washer has been spinning slow or not spinning after extra rinse for a while. Tonight when I went down to get the clothes out of there they were soaked after a normal cycle. I set it to spin again, and it started making pumping noises and spinning very slowly but not water came out of the...

Alrighty, So I have a Maytag A106, the washer fills, and timer runs through the cycle, but does nothing else. I replaced the belts and the motor since the old one was VERY hard to turn (bad bearing I presume) and I cleaned all the nasty dirt from the years of service off of it. Since the motor...