July 7th, 2006, 06:32 AM
Kenmore Electronic 90 Series - dead control panel
Originall problem: My dryer would stop few minutes after the begining on the cycle. It would do the same after I took out the drum and the belt. So, I replaced the motor.
New problem: The control panel is completely dead. I cannot select anything. The door light and the light above the touch pad are working.
I thought that maybe it is the thermistor since it has no continuity but after reading some of the postings I'm no loger sure about that.
I have checked continuity on all the sensors attached to the heating unit and they are OK.
July 7th, 2006, 08:33 AM
July 7th, 2006, 08:42 AM
I'm thinking that the relay in the control panel has gone bad. There are 2, one is for the heating element and the other one is the one I would check.
By billhig in forum Maytag/Magic Chef/Admiral/Jenn-Air
Last Post: May 28th, 2007, 12:52 PM
By winston in forum Sears Kenmore
Last Post: February 26th, 2007, 07:30 PM
By abes1 in forum Sears Kenmore
Last Post: December 6th, 2006, 12:02 AM
By e_smith in forum Sears Kenmore
Last Post: November 5th, 2006, 11:48 AM
By ACat299612 in forum Sears Kenmore
Last Post: August 3rd, 2006, 01:25 PM
If you feel that you have benefited from this site, and would like to show your appreciation, you can throw a buck or two in the Appliance Blog Tip Jar - Thank you!