Hi. After replacing water hoses, can't seem to properly recalibrate the microswitch. The instructions say with the unit off, turn the adjusting screw all the way clockwise, then turn on and turn the screw counterclockwise until clicking starts, then turn clockwise another half turn.
Makes sense, BUT, it starts clicking pretty much right away. Sometimes it will keep clicking even when water tap is closed.
Does this mean I need a new microswitch? I'm afraid to leave it on when the pilot can light without the tap being on so I've been keeping it turned off.
Any thoughts?
thx!
Makes sense, BUT, it starts clicking pretty much right away. Sometimes it will keep clicking even when water tap is closed.
Does this mean I need a new microswitch? I'm afraid to leave it on when the pilot can light without the tap being on so I've been keeping it turned off.
Any thoughts?
thx!
