DV42H5200EW/A3 Samsung dryer issues - not heating

[anrshawn]

Model Number

DV42H5200EW/A3

Brand

Samsung

Age

6-10 years

About 6 weeks ago my Samsung dryer wasn't heating up, but the drum was spinning like normal. Took it apart and replace pully assembly, thermistor, heating coils. After that worked like a charm, until 2 days ago. Again no heat, but ran like normal. Found the thermistor had blown again and waiting for part to be delivered today. I'm concerned there is another problem somewhere else that is causing this issue. Any thoughts would else could be causing this problem?

 

[Jake]

Hi,

When you say thermistor, do you mean the thermal fuse? This one:
DC96-00887C


Did you check for a vent restriction?

The number 1 cause of a thermal fuse to blow out is a vent restriction either in the vent exhaust hose in the back of the dryer or outside where the vent duct vents outside.

Whenever I replace the thermal fuse I always Pull the dryer out from the wall, then check that vent exhaust hose for lint clogs, and go outside the house and do the same where it vents outside.

 

[anrshawn]

No its this part list below, I replaced it today and no change in the dryer heating up. I have checked all the venting, no blockages.

Thermistor DC32-00007A​

 

[Jake]

Ok, our other tech bigbuck posted what else could cause this no heat issue:

FIXED - DV45H7000EW/A2 Samsung dryer not heating

dryer runs but no heat. took dryer apart, element is good - 11 ohms, new thermistor, high limit fuse is good, therm sernsor is good, wiring is good, motor contacts work, BUT NO HEAT. relay on PCB never makes contact. have 3 control boards and none of them work - relay never makes contact to...

www.applianceblog.com