- Model Number
- GLTF2940FS2
- Brand
- Frigidaire
- Age
- 6-10 years
Our washer started beeping constantly with error code E90.
Upon searching the web, we found a workaround to use a blowdryer on the back of the circuit board and it worked. The bad news is that we constantly need to turn off the power and open it back up each time we do laundry.
We purchased a new board from Amazon that says is compatible with our washer. Upon installing, the pre-sets are not the same as they used to and some just show '"---" when the setting is selected. For example, Normal cycle would be 44 minutes and it was now 23 (with the same load of clothes sitting in it).
We also tried holding "Spin" and Soil" buttons to reset the settings (on both the old board and new) and it doesn't do anything.
Any help would greatly be appreciated!
Upon searching the web, we found a workaround to use a blowdryer on the back of the circuit board and it worked. The bad news is that we constantly need to turn off the power and open it back up each time we do laundry.
We purchased a new board from Amazon that says is compatible with our washer. Upon installing, the pre-sets are not the same as they used to and some just show '"---" when the setting is selected. For example, Normal cycle would be 44 minutes and it was now 23 (with the same load of clothes sitting in it).
We also tried holding "Spin" and Soil" buttons to reset the settings (on both the old board and new) and it doesn't do anything.
Any help would greatly be appreciated!