Frigidaire Gallery Dishwasher FGID2466QF PF code

[Elacon225]

Model Number

FGID2466QF

Brand

Frigidaire

Age

More than 10 years

Frigidaire Gallery FGID2466QF gives a PF code. When I unplug and plug back in, the motor cranks and then does nothing. I tried to clear the error by holding cancel, it just blinks an then shuts off. I tried to get it in diagnostic mode, but it stays on the pf error. Power is good at the plug and to the junction box. Ideas?

 

[rickgburton]

PF Flashes when a Power Failure has occurred.

To activate the Water/ Service Test, cycle the circuit breaker to put the unit in Power Failure Mode.

Simultaneously press “DRY” and START/CANCEL for 3 seconds.

The dishwasher will then step through the test cycle per the chart.

If START/ CANCEL is pressed during the test the current step is terminated and the test advances to the next cycle step.

 

[Elacon225]

I am having the same issue with this unit. The last time it just started working. It won’t enter the diagnostic mode with the combination you gave. The only way to clear the error is to open or close the door and then it goes blank with no response until it is power cycled. Any ideas?

 

[Jake]

Rick @rickgburton has been out sick since Jan.12th 2022 with a serious illness, we are hoping and praying for a speedy recovery!

We need the complete model number, your missing 2 digits after the "QF"

Read it from the model number tag located inside the door on the tub frame.

 

[derek654]

I am having the same issue with this unit. The last time it just started working. It won’t enter the diagnostic mode with the combination you gave. The only way to clear the error is to open or close the door and then it goes blank with no response until it is power cycled. Any ideas?

I got exact same symptoms when I open the door or close it the pf goes away blank and nothing works.

Model # FGID2466QF4A

 

[Jake]

Ok, then it sounds like the problem is in the main control board.

Main Control Board 5304514670