FIXED GE Dishwasher GDT695SSJ2SS UI(user interface) issues

[Ron Michael]

Model Number

GDT695SSJ2SS

Brand

GE

Age

1-5 years

Replaced Control board and UI board wire harness checks out ran continuity test on all sets. Note 14.1 volts from control to UI. UI buttons beep but no lights. No lights when I press and hold start and select. Boost light will come on randomly. also have replaced the UI board twice and verified the profile. What have I missed totally frustrated'
.

 

[rickgburton]

Turn off the power to the machine and access the main control board.

Restore power to the machine and check the status LED. Is it on, off, or blinking a pattern?

 

[Ron Michael]

Thanks, Rick for replying to my issue. Good news, dropped the board turned back on the power and to my surprise, the dishwasher lights were on. I checked the LED and it was 0ne light per 3 sec {waiting on cycle select} I selected the short cycle and ran a load of dishes. I guess after the repair I didn't give it enough time at either power on or off don't know. The only outlier out there was somehow it went into CSM from voltage loss to ground, what a mystery.

Appreciate your guidance to go back in to look at the LED.

Thanks

Ron

 

[rickgburton]

Anytime!