GE dryer GTD75ECPL1DG program Wifi

[Sebas]

Model Number

GTD75ECPL1DG

Brand

GE

Age

1-5 years

Recently the main board for my GE Dryer GTD75ECPL1DG was replaced. The model code was setup correctly to 3 as stated in the instructions.

The problem is that to setup the wifi, the instructions say to hold TEMP button for 3 seconds to be able to see the wifi led flashing. I’m doing that and wifi led isn’t appearing.

Is there any programming needed for wifi when the main board is replaced?

 

[Jake]

Hi,

Here's the main control board for your model:

GE WE04X29098 Control Board Assembly (AP6889037) - AppliancePartsPros.com

This OEM part is a control board for washing machines. The control board is the main computer that controls the essential functions of the washer. If the washer is no longer spinning, rinsing, or draining properly, it might be time for a new control board. Luckily, replacing the control board...

click.linksynergy.com

Another member was having a similar issue, look at what he did in post #6 here:

FIXED - New control board on GE dryer GTD75ECPL0DG programmed with wrong Model Code. How to reprogram.

I have a GE dryer model GTD75ECPL0DG. It stopped working and I had a service man come out and he stated it was the main board that went out. Which I find sad since it is only 2 years old. He ordered a new part WE04X29098 and put the board back in. The problem is the wifi and steam refresh are...

www.applianceblog.com

Jake

 

[Sebas]

Thanks, correct the main control was replaced.

I studied the other thread with a similar issue, however I’m not able to get the dryer wifi LED signal blinking to begin to the pairing process, not sure if it is because something was missed during the programming of the new main controller.

Any thoughts?

 

[Jake]

Nope, that's all the information I could locate, you'll need to contact GE about this problem.

Jake