GE GDT695SSJ5SS not working

[Acair2222]

Model Number

GDT695SSJ5SS

Brand

GE

Age

1-5 years

So I have this dishwasher that what’s never been an issue. Then today after a cycle it was continuously beeping like the door was open. I went to check it out and the controls went blank. Couldn’t press anything. It came back on, we ran a cycle and it seemed ok. Woke up the next morning and the bottom was filled with soap. I tried to run another cycle and it all went blank and everything stopped again 5 mins in. There was a rapid clicking noise from the board and controls went blank. It comes back on and starts the cycle. I looked at other posts. The LED on my control board is a rapid steady flash when it is running. Any assistance would be greatly appreciated

 

[Jake]

The LED on my control board is a rapid steady flash when it is running.

That indicates your machine control board(underneath the dishwasher) is working good.

The problem is the UI Board.

Here's the UI(user interface) Board for your model you can order: WD21X31902

Many members had this same issue, here's our main thread on it:

FIXED - GDT695SSJ5SS needs to be reset frequently

We have a GE Model GDT695SSJ5SS, Serial TL846400B that needs to be reset with increasing frequency. Some time after a cycle has completed the display will eventually turn off, and the buttons appear to be unresponsive. I have tried holding the start button for more than 5 seconds but nothing...

www.applianceblog.com