colinwerner
Member
- Model Number
- GHDVH680J0MS
- Brand
- GE
- Age
- More than 10 years
The washer stopped "working". Had E54 (which I cleared and now no longer shows up)...
6 ohms across the three terminals on the motor.
Sensor (two yellows on P9) has 114 ohms.
Trying to run t10, t11, or t14 results in nothing (machine just beeps back at me!)
I disconnected the red / blue and I get about 13V on the red / blue terminal without doing anything?
The inverter itself is very hard to pull out, so I gave up on that.
Seems like it is the control board? Anything else I should do?
Is it worth fixing? A new board is ~$400...
6 ohms across the three terminals on the motor.
Sensor (two yellows on P9) has 114 ohms.
Trying to run t10, t11, or t14 results in nothing (machine just beeps back at me!)
I disconnected the red / blue and I get about 13V on the red / blue terminal without doing anything?
The inverter itself is very hard to pull out, so I gave up on that.
Seems like it is the control board? Anything else I should do?
Is it worth fixing? A new board is ~$400...
