KDPM804KPS KitchenAid Dishwasher will not drain when hot?

[Ron J]

Model Number

KDPM804KPS

Brand

KitchenAid

Age

1-5 years

Kitchenaid dishwasher #KDPM804KPS

Start Dishwasher on normal cycle time is 2:53 minutes count down, it get to 46 minutes

And stop counting down this last for 12 minutes and then start flashing F9E1 error code,

when I open it up the hot steam comes out but water is standing on the bottom

as high as the bottom of heating element .

Now if I let it cool down and press cancel and drain it drain just fine

or if I only use the rinse only cycle it works fine, I have replace the control board

and the same thing happens?

It is only two years old.

 

[leosar]

9-1 or F9E1
Electronic control board can't detect the position of the diverter disc

 

[Ron J]

9-1 or F9E1
Electronic control board can't detect the position of the diverter disc

Thank you for your reply, I did replace the control board and it change nothing

 

[Jake]

I'm attaching your tech. data sheet below.

F9E1 Draining: Product Not Draining

Here's the drain pump for your model: W11412291

I helped another member with this similar problem here:

FIXED - Kitchenaid Dishwasher KDTM404KPS not draining error code 9 - 1

I have a 22 month old KDTM404KPS Dishwasher that displays a blinking error code 9 pause 1 pause. According to the tech sheet it means product not draining, cycle ends. Opening the door there is water standing in the bottom of the dishwasher. I press the cancel drain button but the unit does...

www.applianceblog.com

Sounds like the drain pump is bad, or still clogged, you took apart the drain pump completely and cleaned the impeller out? Dog hair may still be wrapped around the drain pump motor impeller, causing it to overheat and not run after first two drain cycles.

Yes, F9E1--->Draining: Product Not Draining

Here's the drain pump for your model: W11412291

On this model you have to remove the entire dishwasher to get access to the drain pump.

This video shows you how: https://cdnapisec.kaltura.com/index...id/37942631/entry_id/1_r13dks86/embed/dynamic

 

[Ron J]

Thank you,

Now if I let it cool down and press cancel and drain it drain just fine

or if I only use the rinse only cycle it works fine

 

[Jake]

Now if I let it cool down and press cancel and drain it drain just fine

Yes, I know that, but it still should drain fine when its hot as well, so that tells me the drain pump is faulty.