Kenmore Coldspot 106.53232300 ice maker that is not working

[brucevos]

I have a Kenmore Coldspot 106.53232300 ice maker that is not working. I have tested the solenoid by using the water switch, water is getting to the icemaker, I measured voltage of 115V on the board. Tried the jumper to harvest and did not notice any result. What should I do to keep troubleshooting or is there an obvious answer given the info above?

 

[Jake]

When you jumped T and H on the ice maker module did you have the door switch pressed in at the same time?

If so and the ice maker is not cycling, then the ice maker itself is the culprit.

Here's the ice maker assembly for your model:
4317943 Whirlpool Icemaker Kit

 

[brucevos]

Hey Jake, got the new one and installed. I used the original harness. Still no joy. Where’s the picture that shows how to check voltages? Should I charge the harness too?

 

[Jake]

Where’s the picture that shows how to check voltages?

In this thread:

Kenmore Elite Refrigerator 106.71204100 Ice Make Failure

Hello - The ice maker in my Kenmore Elite Coldspot, model #106.71204100 stopped working. What I noticed is two fold. Water stopped flowing into the ice making tray, second the fan at the front of the maker seemed to stop. Maybe one is related to the other. I recognize there are many components...

www.applianceblog.com

Should I charge the harness too?

Yes, that black wire with the white thermal fuse on it may be bad, you can ohm test it and see if your meter reads anything.