Rvelazquez1123
Premium Member
Hello,
Hope you and yours have been well through all of this. Sorry I couldn't find a more appropriate board. Please let me know if I should move my thread somewhere else. Hopefully someone out there knows about stand mixers!
I'm fixing an older model KitchenAid and I'm looking for your expertise.
I have a KT2651XBU serial # WL3063260.
I'm looking to replace the older 8-spline motor, part # 9703571. I ordered a new 10-spline motor, part # W10247536 as it was listed online as a suitable replacement.
Unfortunately, the new W10247536 seems a bit too big. It doesn't seem to sit properly in the housing.
Do you have a suggestion? Is there a 10-spline motor that will fit this model? Or could I somehow frankenstein parts from each motor to make it work?
Any knowledge is greatly appreciated. Thanks again and take care!
Hope you and yours have been well through all of this. Sorry I couldn't find a more appropriate board. Please let me know if I should move my thread somewhere else. Hopefully someone out there knows about stand mixers!
I'm fixing an older model KitchenAid and I'm looking for your expertise.
I have a KT2651XBU serial # WL3063260.
I'm looking to replace the older 8-spline motor, part # 9703571. I ordered a new 10-spline motor, part # W10247536 as it was listed online as a suitable replacement.
Unfortunately, the new W10247536 seems a bit too big. It doesn't seem to sit properly in the housing.
Do you have a suggestion? Is there a 10-spline motor that will fit this model? Or could I somehow frankenstein parts from each motor to make it work?
Any knowledge is greatly appreciated. Thanks again and take care!