MVWC465HW2 Maytag Washer - Will not go to spin in Auto-Sense Fill but is fine in Deep Fill.

[rhodej5914]

Model Number

MVWC465HW2

Brand

Maytag

Age

1-5 years

MVWC465HW2 - Washer Will not go to spin when the 2-position switch in on Auto-Sense Fill but works fine when switched to Deep Fill position.
Transmission, splutch and shift actuator were recently changed under warranty. Possible control board or selector switch issues?
After trans replacement there is a rubber squeak noise at the start of the spin from maybe the new center seal, don't see how it would be related though.

 

[Jake]

Here's the tech data sheet for your model: https://drive.google.com/file/d/1_VSk1cuHgkuPVOZYUPCZVccBNI6G6KQG/view?usp=share_link

Make sure no water is in the tub first, then On page 2 do--->ACTIVATING THE SERVICE DIAGNOSTIC TEST MODES
Then on Page 3 do--->CALIBRATION MODE: Page 4

 

[rhodej5914]

Thank you for that but I'm actually an appliance technician and have the tech sheets and knowledge but am stumped on this issue.