• Please note, some of the links on our site are affiliate links (Learn More)

MVWX655DW0 Washer does not go to wash cycle after sensing. After sensing it starts filling the tub, but that stops as well after a min.

Sharma

Member
Joined
Jun 3, 2022
Messages
1
Location
Winnipeg
Model Number
MVWX655DW0
Brand
Maytag
Age
6-10 years
MVWX655DW0 Washer does not go to wash cycle after sensing. After sensing it starts filling the tub ( still on sensing light ON) but then water also stops as well after a min. while it is trying to fill the tub, sometimes purges hot water with visually clear pressure on hot water valve. If I put it on drain and spin cycle, then that is working fine but when normal cycle just doesn't switch from sensing to wash cycle.
 

Jake

Appliance Tech - Admin
Staff member
Joined
Aug 24, 2004
Messages
134,025
Location
Redmond, Oregon
Here's the parts diagram for your model:

Here's the tech. data sheet for your model: https://drive.google.com/file/d/1xuYO9fupRwHGgiQSOp1ToyXkuermivDL/view?usp=sharing See if you get a fault code to pull up.

You can get into the ACTIVATING THE SERVICE DIAGNOSTIC TEST MODES and see what fault codes you get, if any.

On Page 2 of your tech. data sheet do: ACTIVATING THE SERVICE DIAGNOSTIC TEST MODES

Then do FAULT CODE DISPLAY MODE on Page 3--->Then you can see what fault code/codes you are getting on Page 6 and Page 7: FAULT/ERROR CODES

Jake
 
If you feel that you have benefited from this site, and would like to show your appreciation.
Top