• Please note, some of the links on our site are affiliate links (Learn More)

Passes all manual tests except High Spin. Maytag Washer MVW360AW0

gdmtx

Member
Joined
May 6, 2022
Messages
1
Location
Palm Springs
Model Number
MVW360AW0
Brand
Maytag
Age
6-10 years
Having some trouble with my Maytag Centennial Commercial washer. Cycles intermittently won't start, or will run up to spin then stop, or somehow skip the spin cycle but at least drain. Basically, random.

When I get it into automated test mode, it runs every test but flashes lid lock at the end. Manual? Seems to pass every test but High Spin (High Agitation + Low Spin = fine). My next step was to open up the lid, but wasn't sure there was a more obvious answer. I haven't seen anyone write in with low spin working but high spin failing?

Thanks
 

Jake

Appliance Tech - Admin
Staff member
Joined
Aug 24, 2004
Messages
130,198
Location
Redmond, Oregon
Hi,

Please recheck your model number, nothing pulls up for MVW360AW0.

I did locate this one as good: MVWC360AW0--->If that is your model number I'm attaching your tech. data sheet below.

Get into the ACTIVATING THE SERVICE DIAGNOSTIC TEST MODES and see what fault codes you get, if any.

On Page 2 of your tech. data sheet do: ACTIVATING THE SERVICE DIAGNOSTIC TEST MODES

Then do FAULT CODE DISPLAY MODE on Page 3--->Then you can see what fault code/codes you are getting on Page 6 and Page 7: FAULT/ERROR CODES

Let us know what you find.

Jake
 

Attachments

  • Tech Sheet - W10468340 - Rev C.pdf
    3.7 MB · Views: 22
Last edited:
Top