URGENT!! Jenn-air oven slow to heat, wife will kill me if not fixed.

[eturnit3]

Please help, thanksgiving is imminent.
I just got a Jenn-air model# SCE30600
it took about 2 1/2 hours to get to 350 degrees, it seems to drop temp and then jump up, and hold for a bit, and then drop down again.
any assistance you could give would be paramount to my continued well-being.

Thank You in Advance

 

[Jake]

Sounds like its either a loose power connection when it was hooked-up to the back of the ranges terminal block, or 1 of the double throw breakers is off.

Who installed it?

If the store where you bought it at delivery guys did, then just call the store tomorrow, and they will make it a priority to get someone back right away.

Jake

 

[eturnit3]

This stove is 9 years old and We are the second owners.So any repair is probably in our hands.Thanks.

 

[Jake]

Ok, I thought it was brand new.

There should be another letter after that model#SCE30600 like a W or B.

Then you could have a bad control board or oven sensor.

Here is the clock oven control board assembly for your model# with the W after it:

[FONT=Verdana, Arial, Helvetica, sans-serif]Electronic oven control assembly[/FONT]​

Jake

 

[eturnit3]

The model ends in a B

The model ends in a b, will this alter which component i need to get. I had found the repair clinic site before i found this one. Are there tests i can do to determine where the problem originates from, because some of the components i have seen are quite spendy, and from automotive experience, electrical troubleshooting by means of part replacement can be an expensive undertaking, again thanks in advance.

 

[Jake]

Thanks, that model# with the B after it is the same control board as the one listed above.

Jeff1 has a good webpage for help on this ranges and tests:
http://www.applianceaid.com/elecrange.html

Jake

 

[eturnit3]

thanks

thank you so much i will give it a try

 

[Jake]

Glad to help!

Jake