WTW6300SW0 Whirlpool Cabrio Wont spin

[aj10203]

Model Number

WTW6300SW0

Brand

Whirlpool

Age

6-10 years

Hoping you experts can help me fix the no spin issue with my whirpool cabrio top load washer.

Initially, the washer was very loud during the spin cycle, so I replaced the bearings, shaft, and seal with oem parts. While doing this, I messed up the RPS, so I replaced that with the entire kit that included the wiring harness.

Now the washer will not spin on its own.
I can spin the tub by hand very easily.

When in diagnostic mode, I get F82, F41, F51, and F50.
While in manual diagnostic mode, and I enter the spin test, if I help the inner tub start spinning, it will spin fine throughout all rpms. Once it stops though, it will not start again on its own.

Any ideas as to what I need to replace to get this thing back up and running?!?

Thanks in advance !!

 

[aj10203]

Any ideas ?

Drive Motor?
Misaligned bearings? I did use the installation tool, and spins fine when I start the tub spinning by hand..

 

[Jake]

While in manual diagnostic mode, and I enter the spin test, if I help the inner tub start spinning, it will spin fine throughout all rpms. Once it stops though, it will not start again on its own.

Sounds like its still binding up when it try's to spin on it's own, did you install the OEM bearing kit? You didn't install aftermarket bearings did you? Aftermarket ones will not work properly on this machine.

Here's the OEM tub seal and drive shaft repair kit:
Tub Seal and Bearing Kit W10435302


Here's the OEM bearing and seal tool:
Bearing Driver W10447783

 

[Strongfam]

Sounds like its still binding up when it try's to spin on it's own, did you install the OEM bearing kit? You didn't install aftermarket bearings did you? Aftermarket ones will not work properly on this machine.

Here's the OEM tub seal and drive shaft repair kit:
Tub Seal and Bearing Kit W10435302


Here's the OEM bearing and seal tool:
Bearing Driver W10447783



I’m have the same issue-

Originally my bearings went out with the indications on the bottom of the washer - so I replaced them but durning washing it made load banging as well as durning the spinning cycle. So first I bought new set of rods which j thought might work but still the tub wasn’t really banging on the sides more of the plastic top lid was hitting the top of the washer as if the basket was too high. So I thought I didnt place the bearings and staff in low enough for clearance so i redid the process but bought the product from another supplier on Amazon. Is it possible the staff could be different- I’m not sure why it won’t spin. Thinking of reordering from the original supplier I used and go from there, any advice?

I also replaced the basket hub, drain miter (as I got a SD ERROR) which I’m return cause both work fine, and purchase a Rotor Sensor as well.


Thanks in advance.